I am trying to make a carb spacer with the stainless steel nipple for the PCV valve. I am hoping someone out there has one off their car that they can take some dimensions for me. Can anyone get me dimensions A, B C and D as shown in the attached picture.
Thank you,
Corey
Corey
A .08515
B (couldn't tell exactly where you are measuring to so I went to center of bulge) 1.2625
C Because of B I did overall measurement so use this minus B to get your C 1.6155
D .5475
Your measurement of .500 actually measured .515
Thank you Tim! Much appreciated.
Corey
Tim,
Was "A" supposed to be .8515 not .08515?
Corey
Are using a 3D printer for this?
I was able to find a spacer on Ebay but it came without the stainless tube. Luckily it did have the slot in the edge to accommodate the tube which I did not even know until the spacer arrived. So I was able to make my own tube to bond into the spacer. I think it turned out real well. I now have the tool used to put a bead in the end of 3/8", 1/2" and 5/8" diameter tubing.
Corey
Nice job! ;)
That tube should have been pinned in place originally. It's tough to keep it in place.