SAAC Forum
The Cars => 1969-1970 Shelby GT350/500 => Topic started by: Bill on February 21, 2021, 05:24:46 PM
-
Starting my carb reinstallation, have the Felpro installed above and below the spacer now and have a wonderful vacuum leak (high pitched whine). Thinking my custom cut MrGasket picture below might alleviate the vacuum leak. All to be installed dry I assume as that is what I am used to. Or is there a proper part number I have yet to stumble across that will work without custom cutting?
-
Check the spacer. The reproduction for my 68 was not flat. I used a large flat file to get it flat. Mike
-
Sand paper on a pane of glass is also a good way to get flat surfaces. :)
TOB
-
Check the spacer. The reproduction for my 68 was not flat. I used a large flat file to get it flat. Mike
Sand paper on a pane of glass is also a good way to get flat surfaces. :)
TOB
Checked on a the glass table in the house, SWMBO was not amused ;)
-
You have to wait until She leaves the house... :-X
TOB
-
You have to wait until She leaves the house... :-X
TOB
Sure, now you tell me ::)
-
U need 2 black top photo gaskets not the mr gaskets type
-
U need 2 black top photo gaskets not the mr gaskets type
Two on the bottom and one on the top of the spacer between the spacer and the carb?
Or like I have now, one at the bottom between the spacer and the intake, and one between the spacer and the carb?
Thanks in advance,
Bill
-
1 black type on both sides of spacer
-
1 black type on both sides of spacer
Thanks