Can anyone recommend a one piece fuel line for the 67 GT500 that actually fits without making a bunch of changes to it? Purchased one from NPD and although it says it's for the GT500, it's quite different than the one I have on it now. Also, any easy way to thread one of these in place??
Thanks.
Just to make sure, you know the one piece goes down the driveshaft tunnel right.
Yes I do.
When I did it the car was a bare shell (no parts on it) on tall jack stands after painting, it was not tough.
Is your car complete, rear suspension and drive shaft in it?
Yes, drive line, rear suspension, exhaust system is all in place.
Mine also was bare shell after painting and I didn't think was hard. Only part was the bend into the engine bay around the frame had to be manipulated a little.
Quote from: nwfire on February 13, 2022, 04:40:55 PM
Yes, drive line, rear suspension, exhaust system is all in place.
try removing and or dropping some of the rear components/assemblies until you can sneak it in.
The Classic Tube stainless fuel line I installed fit fine.