SAAC Forum
The Cars => 1969-1970 Shelby GT350/500 => Topic started by: SFcarbuff on January 08, 2019, 11:05:31 PM
-
Hi, I am looking for pictures, the correct part numbers and parts for a 1969 428 C-6 trans. The parts I am looking for are the levers which come out of the trans where the shift rod and kickdown rods attach. Thanks for your help!
-
bill at mansfield mustang just get on his site go to trans section to the c6 page he has all the unique parts.
-
Hi thanks foe the info. I still need a picture of linkage if someone has one.
-
I just want to say, don't everyone think these are hard to come by, I thought they were until I took a job at Ohare airport, I would have to say 85% of the equipment at the airport uses 4.9 litre 300ci Ford engines and C6 transmissions, And every one of them has that 69 lever in them, also Every once in a while I have seen some 70 ones, Any trans shop can get them, they are severely plentiful.
-
Picture on the Mansfield site.
Manual control shift linkage is different between floor shift and column shift for automatic transmissions.
-
Here’s a photo of C6 out of mine. This is the original trans from my 70 GT500.
-
Thanks SJ The photos were very helpful. . The suggestion for Mansfield Mustang was super too !
-
There is a rubber coated wrap around strap that holds the wire in place on the top switch bolt
-
Good to know Thanks