Hi all. Any ideas how I could get back my hood part number ?
Previous body man made a rough job and sand it out as it has been touch at front long time ago. Hood still has potential. Just a bit bowed as usuel.
Quote from: Shelbypat on April 18, 2019, 12:38:35 PM
Hi all. Any ideas how I could get back my hood part number ?
Previous body man made a rough job and sand it out as it has been touch at front long time ago. Hood still has potential. Just a bit bowed as usuel.
The short answer is to make a mold using a hood that still has the numbers . After you make the mold and produce a positive of the engineering number you then graft that into place. There are various ways to accomplish the end result.
Here you go.....
https://www.ebay.com/itm/NOS-Shelby-Fiberglass-Hood-1969-Lower-section/282991201398?hash=item41e3970c76:g:eUkAAOSw8FBbEacG
NOS Shelby Fiberglass Hood 1969 Lower section. Assemblyline lower hood section , original smooth AO Smith injected fiberglass lower half with raise S9MS engineering # visible.
Tks for inputs. I've ordered silicone mold kit. I'll try it.
Patrick