If you own a 69-70 GT, could someone please check your car and provide me the dimension (as shown in the attachment) of the driver side hood pin bracket. I need the measurement from the mounting side of the bracket to the center of the latch opening. If all else fails, fabricate. Wish me luck.
2.75 inches
I do appreciate the offer. Branda, along with EVERYONE else, no longer has them. The manufacturer died and no one is reproducing them. I have one side coming and was going to fab up the other side. I just want to make sure of the dimensions before I make it. I may take you up on your offer, but right now, what I am looking for is the dimensions for the driver side, just in case it is different than the passenger side. Better to be safe than not have it fit properly
Brackets are symetrical
Quote from: Coralsnake on October 15, 2019, 02:44:43 PM
Brackets are symetrical
+1 . With one side you will have the dimensions to make the other side.
Thanks Bob. I just wasn't sure and I didn't want to take a chance. Did you receive my email?
Quote from: kasearch@ix.netcom.com on October 15, 2019, 03:03:25 PM
Thanks Bob. I just wasn't sure and I didn't want to take a chance. Did you receive my email?
Yes I did.