SAAC Forum
The Cars => 1967 Shelby GT350/500 => Topic started by: tag031 on October 22, 2019, 03:05:08 PM
-
I'm sure this question has been covered before but......
I'm looking at a 67 Shelby GT500, 4-speed. I'd like to know more specifically the VIN location on the transmission? Passenger side, drivers side, top, bottom etc. Thanks in advance.
-
I'm sure this question has been covered before but......
I'm looking at a 67 Shelby GT500, 4-speed. I'd like to know more specifically the VIN location on the transmission? Passenger side, drivers side, top, bottom etc. Thanks in advance.
On the pad located on the bottom side of the main case of the trans near where the tailhousing bolts to the main case .It is easy to spot if there .
-
another view ...
-
Question: which / when were the transmission stamping pads machined (smooth) versus cast (rough)?
Thanks!
-
Question: which / when were the transmission stamping pads machined (smooth) versus cast (rough)?
That has been a long deep discussion IMHO and may or may not be tied to when the car was built. Of course machined/ground surface can always be a clue that it may be a restamp even if it was originally done that way ;)
There are compression tests that can be done to determine if there is another/different stamping in the metal on the pad but not that easy to do
Still seeking clues and examples from other car lines built on the same line at San Jose for comparison
Of course checking a transmission would also include the documenting of the casting date found on the main case also
-
That has been a long deep discussion IMHO and may or may not be tied to when the car was built. Of course machined/ground surface can always be a clue that it may be a restamp even if it was originally done that way ;)
There are compression tests that can be done to determine if there is another/different stamping in the metal on the pad but not that easy to do
Still seeking clues and examples from other car lines built on the same line at San Jose for comparison
Of course checking a transmission would also include the documenting of the casting date found on the main case also
and the transmission tag riveted on the side which would have the model and sequential number for that specific transmission relative to others in cars from the same DSO.
-
and the transmission tag riveted on the side which would have the model and sequential number for that specific transmission relative to others in cars from the same DSO.
+1 Good addition JD
-
The Ford VIN can be found under the Shelby Plate and under the fender in this area. On the Apron passenger side there is also the Shelby Vin near the shock tower.
-
Thanks Jeff and JD! :D
-
The Ford VIN can be found under the Shelby Plate and under the fender in this area. On the Apron passenger side there is also the Shelby Vin near the shock tower.
You forgot to mention the Ford VIN stamped in the apron on the passenger side typically under the fender once installed. ;)
-
Yes I was in a hurry when writing this
-
Some cars also had the Ford Vin tag still riveted on the door. Ive had 4 of these cars with the tag on the door that they didnt remove at Shelby
-
Thats rare, did you ever made pictures of these, I have never seen them with a door tag
-
Here you go Kent...
I purchased a 67 GT 500 project a few years back...
And there it was...
The door tag..!
Really cool to see a door tag with a "Q" for an engine code