Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - khp352

Pages: [1]
1
1969-1970 Shelby GT350/500 / Re: New wiring no power to fuse block
« on: April 26, 2020, 08:22:05 AM »
Thanks for the help. I found that I was being apparently overly cautious and did not have the main fuse block as tight as I should. Put some extra turns on it and it had power. Also once figured out I needed the 4plug that goes back into itself on the firewall I had ignition. Buying one in parts with cobbled back together wiring to go by has been interesting. Again thanks for the help and ideas.

2
1969-1970 Shelby GT350/500 / Re: New wiring no power to fuse block
« on: April 04, 2020, 04:52:48 PM »
I have power to most of it now. The ground wire that goes to the center stud on the oil gauge where does the mate go. Only 2 studs on the amp gauge.  Thanks for the help. 

3
1969-1970 Shelby GT350/500 / Re: New wiring no power to fuse block
« on: March 29, 2020, 07:17:55 PM »
According to the Shelby supplement wiring book I have I believe I have everything connected right. I also have the ammeter junction block wires according to cobranda website I believe. I will take pictures of wires I can’t find in book. All wiring is new except the plugs going to fog/interior switches. There is a what appears to be a black jumper wire at the gauges, blue/white wire that runs lighter and a female red/blue that comes out of male connection. I am including pictures. Thanks for the help! 

4
1969-1970 Shelby GT350/500 / Re: New wiring no power to fuse block
« on: March 22, 2020, 03:25:59 PM »
My issue is in the console then. I will trouble shoot there. I contacted the company that sold me the looms and they sent me to the manufacturer. The manufacturer/owner told me “I make the product I’m not a mechanic”.  Thanks for the help!

5
1969-1970 Shelby GT350/500 / New wiring no power to fuse block
« on: March 20, 2020, 02:02:19 PM »
Hi,  I bought a 1969 GT350 in parts. The wiring was cut, spliced and burnt. I bought all new wiring and have power to console through the Shelby wire feed.  On Cobranda website there is an ammeter junction block wiring diagram. I have it wired as shown, but there is a red wire shown that was not in the wiring kit. My question is where do I get the power wire and where does it go as I assume it powers the fuse block which I have no power to.  I can make the power wire if needed.  Any help is appreciated.  Wiring obviously not my thing. Thanks.

6
1969-1970 Shelby GT350/500 / Re: Wiring for 1969 GT350
« on: December 01, 2018, 01:13:46 PM »
Thank You!

7
1969-1970 Shelby GT350/500 / Wiring for 1969 GT350
« on: December 01, 2018, 07:19:36 AM »
Restoring a GT350 and the wiring harness is pretty chopped up.  Looking to replace all of the wiring harnesses.  Looking for a recommendation for a company that has them.  Thank You.

Pages: [1]