Hi Saw an auction advertising ford parts toploaders, heads blocks at Todd Crill Auctions it may get someone a bargin
- Welcome to SAAC Forum.
News:
SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
1967 Shelby GT350/500 / What heads for a 427 in a GT500 clone?
August 01, 2019, 06:09:21 AM
Hi,
I am from New Zealand, Slowly getting parts to build a 67 GT500 clone not a cheep exercise with the exchange rate and freight. Takes a lot of faith to send money to a stranger 1000s of miles away.
Started with a 67 project for wifes 50th it is a 67 S code GT 4spd fastback deluxe interior dark moss green. Was supposed to have the right motor, but only had 8 bolt heads since then got a 428 and 14 bolt heads that is cast date correct for car. Going to put the car back to original as possible.
The other project getting parts to build a Gt500, want to put a 427 in it.
What heads and intake would work/fit best? Have a PI and a proper dual quad collecting dust on the wall.
I am from New Zealand, Slowly getting parts to build a 67 GT500 clone not a cheep exercise with the exchange rate and freight. Takes a lot of faith to send money to a stranger 1000s of miles away.
Started with a 67 project for wifes 50th it is a 67 S code GT 4spd fastback deluxe interior dark moss green. Was supposed to have the right motor, but only had 8 bolt heads since then got a 428 and 14 bolt heads that is cast date correct for car. Going to put the car back to original as possible.
The other project getting parts to build a Gt500, want to put a 427 in it.
What heads and intake would work/fit best? Have a PI and a proper dual quad collecting dust on the wall.
Pages1