Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mr68shelby

Pages: [1]
1
Parts For Sale / 1967-68 Power Steering Cooler-Sold
« on: August 05, 2023, 07:16:30 PM »
Cleaned and painted semi-gloss black. $125 including shipping.


2
Parts For Sale / 1967 Brake Light Warning Switch
« on: August 05, 2023, 05:55:20 PM »
1967 brake light warning switch. I checked this with an ohmmeter and it tested good. $60 including shipping USPS Small Flat Rate Box


3
I took this picture at Sonoma in 2018. It was on a survivor car. I did not take a picture of the VIN. Should all of the cars have the plastic on the end of the handle? Thanks. Mike

4
1968 Shelby GT350/500/500KR / Brake Master Cylinder Rebuild Kit
« on: January 14, 2021, 01:25:29 AM »
Does anyone know a source for a master cylinder rebuild kit for my 68? The only one I can find is from Ecklers and it only has the two pistons in the kit. It does not have the seats and the springs/valves behind them.

Are the seats and the springs/valves the same in another application?

My master cylinder needs to be sleeved and I was planning on putting the rebuild kit in myself rather than have the shop do it.

Thanks. Mike

 

5
I am getting ready to install the vacuum tree for the distributor advance in the thermostat housing. 4 speed car. Mine had been removed at some point in its life. Does the vacuum line to the intake manifold attach to the front or rear PCV fitting? The rear PCV fitting on mine has one unused vacuum port. My front fitting has no vacuum ports at all. But I have a spare one that has two vacuum ports on it. Thanks in advance. Mike

6
1968 Shelby GT350/500/500KR / A/C Heater Control Panel Color
« on: February 24, 2018, 01:02:05 PM »
What is the correct color brown for the A/C control panel? Is there a rattle can that is correct? One of the paint shops here will custom mix into a rattle can if I need to go that route. Thanks. Mike

7
1968 Shelby GT350/500/500KR / 1968 GT500 Valve Cover Gaskets
« on: January 26, 2018, 09:20:50 PM »
What is the correct color to paint the edges of the valve cover gaskets? Mike. #872

Pages: [1]