SAAC Forum

Up for sale an NOS 289, 289 Hipo clutch fork.  Part # C5OZ-7515-B

$80 plus shipping obo

Thanks
Jon

Up for sale an NOS Le Mans 289 Hipo high lift camshaft.  Original tube.  Still covered in cosmoline. 

$500 obo plus shipping

Thanks
Jon

Up for sale a freshly rebuilt/ refurbished tach for most 1966 GT 350's after the 600 serial number range until end of 66 production. Cobra logo on bottom (original dial). Correct needle, cup and bracket.  Date is faint but is Feb 17, 1966.  Ready to install.  This took about 4 months to get back from rebuild.

$1350 plus shipping obo

All in original boxes
NOS Autolite DP-6 dual points SOLD!
NOS Autolite DC-6 condensers $20 each (2)
NOS Autolite DR-5 rotor $75 (1)
NOS Autolite EV-8 C6AZ-6A666-A PCV valves with white plastic rings $45 each (4)
NOS Autolite FG-15 fuel filter 1969 dated $75 (1)
NOS Motorcraft DR-5 rotor $30 no box (1)

All prices obo plus shipping

Thanks
Jon

Up for sale a very nice original 1966 Shelby GT 350 sales brochure with an original Northwestern Ford stamp from Milwaukee, WI on back.

SOLD to Plowhorse!

Thanks
Jon

Up for sale a really nice used C7ZE fan shroud for your 1967 GT 350.  Rectangular Fomoco logo.  No cracks, breaks or repairs.  Original black molded through plastic not painted.  Needs a little clean up and some faint scratches on underside of top (not seen once installed).

PM any interest and I can send more photos.

SOLD to DZ

Thanks
Jon

Up for sale a refurbished by Chockostang power steering assembly line idler arm with C7ZA-3355-B numbers. This one is in raw metal and has been protected with boeshield. For 1967-70 with power steering.

$650 plus shipping obo

Thanks

Jon

Up for sale an NOS pair of upper scoop lights for an early 1967 Shelby GT 350.  Correct lenses and housings.  Lenses marked DZ in oval with the numbers 71-823.



SOLD to Gregg

Thanks
Jon

Up for same a freshly rebuilt/ refurbished tach for most 1966 GT 350's after the 600 serial number range until end of 66 production. Cobra logo on bottom (original dial). Correct needle, cup and bracket.  Date is faint but is Feb 17, 1966.  Ready to install.  This took about 4 months to get back from rebuild.

$1350 plus shipping

Up for sale a very nice original 1967 GT 350 horn button.  When I bought it, the previous owner said it had been 'restored'.  It is nicer than the the one on my car but want to keep mine for sentimental reasons.

SOLD!

Up for sale a very nice used set of rear shock mounting plates.  Freshly blasted, raw and treated with Boeshield.  These are not painted. Ready to install.


SOLD!

Purchased as NOS.  Very nice, if not NOS. Oval fomoco on top, Dorman logo at base.  2.44" back to flat mounting area (2 7/16") and 2.74" from back to tip.

$100 plus shipping obo

Thanks
Jon

Fomoco C6OE-A cast iron water pump core for sale.  Correct for 66-67 289, 289 Hipo, Shelby or Mustang.  Standard steel impeller.  Definitely needs clean up and a rebuild.

$200 plus shipping

For Sal an original set of 1967 GT 350 500 fiberglass quarter extensions.  Need a little bit of work on back side and S7MS part number not visible (probably sanded off in a repaint).

SOLD!

Thanks
Jon

NOS in box OEM 1967 Shelby GT 350 fender emblem. Plastic emblem with emblem facing correct direction.

$225 shipped in US obo

Thanks
Jon

Very hard to find small nipple 1/8" air cleaner base for non-thermactor(smog) applications.  Painted Ford dark blue on bottom and stainless paint on interior.  Ready to install!


SOLD
Thanks
Jon

Up for sale a really nice un pitted pair of original rear spring shock plates.  Freshly blasted and treated with Boeshield metal protectant.  Ready to install. Raw steel, not painted.



Thanks
Jon

Sold!

Up for sale an original 289 Hipo air cleaner lid.  Needs to be rechromed or use on rough survivor. Rust and flaking chrome on surface. No dents or deformation.  Back not so bad.

SOLD!

Thanks
Jon

Up for sale a refurbished by Chockostang power steering assembly line idler arm with C7ZA-3355-B numbers. This one is in raw metal and has been protected with boeshield. For 1967-70 with power steering.

$800 shipped obo

Thanks

Jon

Up for sale a correct power steering idler arm OEM version without C7ZA numbers.  Refurbished by chockostang. 

SOLD!

Thanks
Jon