Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Tor

Pages: [1] 2
1
SAAC Forum Discussion Area / Big block alu Cobra T oil pan
« on: January 04, 2022, 06:32:15 AM »
When mounting on a alu oil pan, do you use the bolts from the original oil pan ore are there "special" bolts fore this job?
Tor

2
SAAC Forum Discussion Area / 9F03R482674
« on: November 05, 2021, 03:53:48 AM »
Hello
This should have been in the flashing yellow section, but I could not figure out how to post there.
But this is the case: I have just been aware of that 9F03M482674 has left Norway and exported to USA.
My advise is STAY away from this car. This car was scrapped in late 70 in Sweden. One bright head here on Norway got hold of the title somewhat, he imported a 70 6 cylinder chassis from Sweden and suddenly this car was back on track again. If you are looking fore a real deal, this is not the car you want. Story of this car is secured with the registrar Vinman

Tor
Norway

3
SAAC Forum Discussion Area / AMK fastner
« on: April 30, 2021, 10:12:19 AM »
Hello
Do anyone have the phone number to Amk fastner?

Tor

4
SAAC Forum Discussion Area / Renewal of subscription
« on: December 10, 2019, 10:02:18 AM »
Hello
I have probelms with renewal of my subscription,I have tried to send e-mail to Jay Talbot fore over a week, no respond.Do anyone have a phone number to him so I could call him.
Tor

5
SAAC Forum Discussion Area / The new registerys
« on: August 28, 2019, 03:30:15 AM »
Hello
Those new registerys are very nice,have bought all 3 of them. In the 66 registery there was a size diffrernce on the writing,I liked the size from page 343 and out,it was easyer to read.
Will the editor of the registerys to come please use that size?
The 66 registery was over 670 pages with 2392 cars in it. Those registerys to come will have well over 3000 cars in them,those registerys will be huge with only a glued spine.
Will it be a idea to split those registerys in 350 and 500 editions to keep the size down on them?

Regards
Tor

6
SAAC Forum Discussion Area / BJ/BK carbs
« on: August 06, 2019, 04:34:27 PM »
Hello
On the bj/bk carbs there is a balance tube between the 2 fuel chambers, on the drawing there is a washer and a O ring on both ends on the tube, where can I buy those washers without buy a complete gasket kit fore those carbs.

Tor

7
1969-1970 Shelby GT350/500 / Antenna
« on: July 23, 2019, 08:31:32 AM »
Hello
Can anyone id this antenna? Is it a PM 300 ?

Thanks
Tor

8
1967 Shelby GT350/500 / Fuel pump
« on: May 17, 2019, 02:54:50 PM »
Did the fuel pump on the 67 500 have date stamps on them?

Tor

9
SAAC Forum Discussion Area / Detroit locker
« on: May 13, 2019, 11:46:55 PM »
What type of oil do you use on the Detroit locker end, thanks

Tor

10
SAAC Forum Discussion Area / Dual 4V induction kit
« on: March 11, 2019, 01:05:38 PM »
In the Ford Hi per parts catalog page 34 is there a induction kit. What carbs is it in this kit? It says 510 cfm carbs.
And which manifold is included here,is it the manifold issued fore the 67 GT 500?

Tor

11
1967 Shelby GT350/500 / Paint diffrences?
« on: February 05, 2019, 12:56:07 PM »
The 67 Shelbys was shipped from San Jose too Shelby American with out the hood and the rear deck lid.
The car  was painted at Ford San Jose,how did they avoid the paint diffrences that could occur when the hood and deck lid was painted at Shelby?

Tor

12
1967 Shelby GT350/500 / Carburator stud nut fore GT 500
« on: February 05, 2019, 12:51:14 PM »
Does anyone have the AMk part number fore those nuts?,and also the part number fore the fuel hose clamps fore the fuel log.

Tor

13
The Lounge / Hunt Palmer Ball
« on: December 11, 2018, 01:47:38 PM »
Hello
Does any one here have a e-mail adress fore this gentleman? He is the owner of a super nice 67 350
Please pm me with his adress.

Tor

14
1969-1970 Shelby GT350/500 / How are 69 Shelby seatbelt dated?
« on: December 09, 2018, 11:44:42 AM »
Is it by day/year , week/year ore quarter/year?

Tor

15
SAAC Forum Discussion Area / Holley carb
« on: November 09, 2018, 11:35:35 AM »
C90F-9510-H
List 4345
What is this carburetor used on? Price?

Tor

Pages: [1] 2