Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Cobra Pack

Pages: [1]
1
Wanted to Buy / Late '63/early '64 Hipo Autolite 4100
« on: February 21, 2024, 10:32:27 AM »
Looking for a Hipo autolite 4100 for CSX2225 from the October 1963 to March 1964 time frame. Please let me know if you have one to sell!

Also looking for a 4 barrel iron manifold from the same time frame.

2
Wanted to Buy / 28 Spline T10 main shaft
« on: October 25, 2022, 08:36:43 PM »
I am looking for a good 28 spline main shaft for a mustang or falcon T10. 

Thanks
Mike

3
Wanted to Buy / ‘63 Galaxie Swaybar End Links
« on: February 10, 2021, 10:39:36 PM »
Looking for 4 ‘63 original/NOS galaxie swaybar end links as used on 289 comp cobras.  These have double threaded ends and are forged with integral stops for the bushing washers.

Thanks!

4
Wanted to Buy / WTB - Original Kidney Bean Wheels
« on: May 05, 2020, 08:00:30 PM »
Probably a long shot, but don’t know if you don’t ask...Anyone have a set of 1960’s magnesium 6” front and 7” rear Halibrand kidney bean pin drive wheels you would sell?  Thanks!

Mike

5
Wanted to Buy / 1963/64 Hipo 289 Distributor
« on: February 29, 2020, 08:18:25 PM »
Looking for a c3of dual points hipo distributor for a 289 hipo.

Also looking for single groove pre-65 pulleys 289 (water pump and crank).

Thanks!
Mike

6
Wanted to Buy / 289 Crank Wanted
« on: November 06, 2019, 10:44:10 PM »
Any standard/standard cranks out there for sale?  Please PM me if you have anything for sale!

Thanks!

7
Wanted to Buy / Autolite Orangish/tan 7mm steel core spark plug wire
« on: September 24, 2019, 12:41:50 AM »
Looking for 1960’s 7mm Autolite spark plug wire in orangish/tan.

Thanks
Mike

8
Wanted to Buy / Wanted: Spalding Flamethrower for a 289
« on: September 01, 2019, 10:22:08 PM »
I am looking for a 1963 era Spalding Flamethrower distributor for a 260/289/302.  Please let me know of any for sale or if you have one to part with! PM me with details.  Thx!

9
I am looking for an original Cobra lettered manifold.  I am looking for an opposed version (fuel fittings face away from each other). PM me if you are willing to sell.

Thanks,
Mike

10
Wanted to Buy / WTB - C3OE Hipo Balancer
« on: July 01, 2018, 12:10:45 PM »
Send me a PM if you have one you are willing to sell!

Thanks
Mike

Pages: [1]