Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Terry Curry

Pages: [1]
1
1967 Shelby GT350/500 / BJ/BK Carburators
« on: July 31, 2019, 01:52:46 AM »
Hello All,
I have a question about the stock carbs that were used on 67 GT 500 Shelby Mustangs, what are the advantages running stock VS other carbs. The reason I asked is when I bought my car it came with Holley 1850-2's that need to be rebuilt and knowing the cost for the re-issue ones being sold by Tony Branda and original ones VS the carbs I have, what are advantages between the three. My car is close to stock except the paint (Very vintage early 70's metallic scallops on the hood) and the engine, a 427 side-oiler with survival motorsports heads so kinda of a "Day 2" vibe so the carburetors are not high on my list at this time  but would like to know if stock linkages and all the other items that get attached to the carbs can stay stock.
The engine has just been built and the carbs are the last thing I need to get ready for the run stand.

Thank you

Terry
1967 GT500 #504
 

2
1967 Shelby GT350/500 / Engine compartment wiring harness clips placement
« on: November 14, 2018, 07:15:54 PM »
I'm ready to install the clips in the engine bay that holds the wiring and after reviewing the Electrical assembly line booklet I was hoping to see pictures or a better diagram on how the wiring was routed and what clips were used where. The PO had drilled about 200 holes in the engine compartment (putting metal wire clamps every 4 inches)  and in the process of changing the engine compartment back to black, (It seems every car I have I have to change the color back to stock, Mustang to black, Tiger from black to body color...ugh) I welded up most or all the holes and looking at other cars and taking pictures  at SAAC at Sears Point this past year I still wasn't sure. I have a running early 1967 6 cylinder mustang available to reference but I know there are differences, especially with the center hi-beam headlights and the Tach wiring. Any help would be most appreciated.


Thank you in advanced


Terry


Shelby Mustang GT 500 #504

Pages: [1]