Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Stubee

Pages: [1]
1
1969-1970 Shelby GT350/500 / Space Saver Canister
« on: April 27, 2018, 09:26:55 AM »
I’m looking for a 1969 Space Saver Canister.

Firstly does anyone here have one? The car is pretty much 99.9999 but I still have at least one arm and a leg left to buy one :)

Baring that I have located a canister but need a little help to determine if it will fit the bill.

The one I found has a full can label on it that says space saver and is in Black and Yellow. My hunting says the 1969 Can has a bottom third label that is in black and silver. If I purchase the other one with the black and yellow label and remove it to place the silver and black label will that work?

I understand that the 1968-1970 bottle is a different diameter then the 1971.

I would have posed pictures but it is not possible now without a third party hosting site.

Let me know brothers what you think.

Stubee

2
1969-1970 Shelby GT350/500 / 1970 Shelby Trunk Decals
« on: February 25, 2018, 01:35:24 AM »
Which one of these paper tag setups is most correct or did they vary from Dearborn and A.O.?
For an early May build 1970 GT 350?

Stubee

3
1969-1970 Shelby GT350/500 / Door Speaker Wires
« on: February 24, 2018, 12:26:45 AM »
Does anyone have good door speaker wires photos?

I know there are supposed to be wire tags on them as well. Any picks of the tags?

Many thanks,

Stubee

4
1969-1970 Shelby GT350/500 / 1970 GT 350 Power Steering Lines
« on: February 18, 2018, 10:50:19 PM »
The placement and tidy appearance of the power steering lines on these cars seems to vary.
Does anyone have a good set of photos for this?

I have seen some cars where the “loops” are seen well down past the bottom of the car floorpan line.

It also seems that there are special line stainless steel line fasteners to hold the lines in place in some of the photos i’ve  seen. Are those “correct” If so where can they be purchased?

Open for any tips and suggestions.

Many thanks,

Stubee


5
1969-1970 Shelby GT350/500 / Door Panel
« on: February 13, 2018, 10:42:47 PM »
For the door panel. The main Handle has a “C Cup• plastic liner. What is the correct fastener/ rivet to be used there?

I.e. Size, aluminum or steel?

I have seen a river there but was wondering what it was and where to get them. Perhaps it was just a standard available rivet.

Many thanks,

Stubee

6
1969-1970 Shelby GT350/500 / 1970 GT 350 Air Cleaner/S Tube
« on: February 10, 2018, 03:00:02 AM »
Congrats on getting the Forum back up.

Is there and S Tube on the air cleaner assembly for a 1970 Shelby GT 350 California emission car?
I have seen pics with and without. Perhaps a few good pics would help if there are any out there.

Many thanks gents.

Stubee

7
1967 Shelby GT350/500 / 1970 GT 350 S Tube
« on: February 10, 2018, 01:02:22 AM »
Congrats on getting the forum back up,

Is there and S Tube on the air cleaner assembly for a 1970 Shelby GT 350 California emission car?
I have seen pics with and without. Perhaps a few good pics would help if there are any out there.

Many thanks gents.

Stubee

Pages: [1]