SAAC Forum

Branda #SBKt10, $19.95, 1968 front plate bracket

Branda sells them or used to sell them. I have a repo from him some where.

pm sent, only have 6

i have 6 of the screws, i belive 64-65 t-bird the same.  where are you located, Im in Sask

use a new gasket. i cant recall needing any lube, but if you do dish soap and water will work. me and a friend did mine.

1967 "A" scratch on back of block, no reinforced webbing on mains. "C" scratch production didnt start until July ?? I dont think 1967 Shelbys received "C" scratch blocks. Others will know more.

235 x60 /15 all the way around, 68, gt500

Thanks Jack. my tilt would not move all of the time. After reading your post. I took a 1/2 inch length of vacuum hose and forced it over the signal leaver. It did the trick.

just wanted to say thanks to all involved.! A great time as always, hope to see you all in Calgary next year!

chey engine orange, is very close

west coast cougars has a video on you tube, or did.

I am not an expert. I have been told that a Lunati #10503 is a clone and that a comp cam #265 DEH is a modern replacement. I have never used either. I hope this helps. Royce has built many engines , and will know.

I.M.M. was a great show in Saskatoon this fall with 350+ cars attending. Im booked for M.T. I really enjoy the shows. Not trailering the 68 500, driving the 19 Bullitt and do so touring after the show.

i think the original steering wheel wrap was made by superior performance products. they had a small G.T.500 stamped in material (very hard to see). Sears sold them at one time in the early 70s.

its been so long, but did other Ford, Mercury products not use the same door opener. 67-68 Merc Park Lane?