Still searching for this pulley...C9OE-9C480-A stamped
Pat
Pat
- Welcome to SAAC Forum.
News:
SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#2
Parts For Sale / Koni Special "D" shocks
April 10, 2024, 11:03:41 PM
Used set. Not originals. $350 plus shipping.
Pat
Pat
#3
Up For Auction / Re: 8T02S143461-01588 on BAT
March 30, 2024, 12:28:48 PM
Gotcha..I saw the picture of the remains of a build sheet....
Pat
Pat
#4
Up For Auction / Re: 8T02S143461-01588 on BAT
March 30, 2024, 11:44:00 AM
This car is a C6 auto but the photos of the build sheet show C8ZE-L radiator 🤷♂️. ?
Pat
Pat
#5
1968 Shelby GT350/500/500KR / Re: 31 spline axle seal spacer (sleave) location?
March 25, 2024, 08:47:06 PM
My original axles. I noticed the retainers are stepped. The NOS ones I have are square.
Pat
Pat
#7
1968 Shelby GT350/500/500KR / 68 brake proportioning valve restoration
March 03, 2024, 03:34:46 PM
Any recommendations for restoration sources?
Thanks, Pat
Thanks, Pat
#8
Wanted to Buy / Re: Rear wheel bearings 68 GT-500
February 14, 2024, 05:43:51 PM
Any other sources for the axle sleeve other than Mustangs Etc.. ? Not implying there is anything wrong with them..
Pat
Pat
#9
Wanted to Buy / Re: Rear wheel bearings 68 GT-500
February 14, 2024, 04:09:50 PM
I picked up a NOS pair of C8DZ-1225-B. Pretty easy to find. These have the same dimensions as the part number you mention. Not sure your ID measurement is correct..
Pat
Pat
#10
1968 Shelby GT350/500/500KR / Re: 1968 GT500 on Craigslist for $7,100
February 06, 2024, 07:02:42 PM
It's important to note that the accident was not his fault.... 
Pat
Pat
#12
Up For Auction / 67 GT500 air cleaner base
January 31, 2024, 08:14:00 PM #13
Parts For Sale / Re: COBRA Air Cleaner Assembly 1967 Shelby GT500 after Car 600
January 24, 2024, 08:51:25 PM
Have heard that Harley Davidson black wrinkle is the best product to use? 
Pat
Pat
#14
1967 Shelby GT350/500 / Re: Trunk lid, bumpers
January 11, 2024, 10:56:07 AM
Was the adjustable bumper threaded through the trunk corner or was there some kind of nut or sleeve it went into? My car has holes in the corners but never found any bumpers.
Pat
Pat
#15
1966 Shelby GT350/GT350H / Re: Have a picture of how the upper clutch return spring attached to the firewall?
January 07, 2024, 07:22:58 PM
Not a Shelby but my 66 GT has this tab under the master cylinder.
Pat
Pat