SAAC Forum

Im in need of the LH Seat attaching bracket for a 67 Deluxe Seat side shield , its the one at the from of the seat, they are left and right brackets.
Anyone have one they can let go?

Confirming the open element air filter for 67 GT350, does it fall under 65/67 F Special?
I measured the repro filter I have right now, and those dimensions are a little more than what's printed here
The replacement number on the sticker goes to a C7ZZ 9600-F which falls under FA-41

Yes it is JD.

I was fortunate enough to find a NOS pair of Upper Scoop Lights and installed them!!

Did they do a continuous weld on the backside or short individual welds?
What finish on your spoke section.

I agree too about using the spring clamps, the photo that I think your referring to does show them quite clearly, thanks always guys!

Are these .590 C clamp's available from Vendors?
And used to attach the short rubber section right at carb on 289 Hipo?

Thanks for your input Bob, always appreciated!

Popular Hot Rodding February 67 shows an engine bay picture, but I'm not seeing a choke cable firewall clip, hard to say in a black & white photo though.

Im looking for the length of an original HiPo 67 Choke Cable.
I see some saying no C on the knob and some say with C, did it vary in 67?
What I think is my original cable has a C.
I bought a repro one a few years back, but the mounting bracket doesn't match up to the style of mine, Ive noticed too that the air vent cable/know has the same style of mounting bracket, but with the addition of the two fasteners that holds it in place combined with the E Brake handle bracket.
Right now the cable is mounted to the right side of steering column and Im told it should be to the left next to the kick panel , but I don't have enough length to move it to the left.
Any help would be appreciated.

I have pictures but can't get them from phone to here?
I think that by seeing the dash mounting bracket, that will tell the story.

Sorry can't you help you there.

Ok, I'll have the manifolds gone over first, I have graphite in a spray, so sounds like there's a plan now.
Thanks everyone!

Ok, where does one find that?

What do most do when it comes to the exhaust manifolds on a 289 HiPo? Do you use them or bare metal only surfaces ?

Just the rubber block?