SAAC Forum

I have a couple versions of the Witteck #16 worm gear clamp to install around the P/S control valve/hoses, can someone comment on which style might be the one or close to what was used?

Do we know what it sold for yesterday?

Ok, well I have a hole in the firewall where there was a sheet metal style screw, but that's it.
Did you leave the J Clip in place or remove it?

Im on the hunt for the hold down clip that secures the choke cable tooth firewall on a 67 GT350
NPD has two versions, which one of these would be the one to use and which fastener screw?
Thanks

That's gotta be 0176, the advertising car, the USL's are more prominent for starters, hub caps, the large letter GT500 rear plate, If it is, Ive never seen this picture before.

I sent you pictures today
Let me know

Here's my introduction mail out pamphlet from Fogg Motors .
0031 being their show car was shipped out October 28/66, possibly the first 67' shipped from LAX as it had to go a distance to New Westminster, BC
Thanks again Vern for finding this in your paper treasures!

I spoke with owner of 0024 today and his is also the big block version, original to his car, never been changed, same as 0031

I have the top rod in photo, always been there and works correctly, I've looked it over and it appears that the jog in one end gives the proper routing,
When I looked it up in MPC , I got a C7 number too
What can others report what they have on their 350 cars?

Bob
I'm  always on board for suggestions, keep them coming please
I'll look into the wire now,
Thanks

Moved the fuel line into the correct loop, scratch another off the list

They want a certain look, but with a high end modern drivetrain and don't seem to mind paying for the combination.
I understand it, but at the same time, it defies my way of thinking it through.
That's life!

There is a fellow that makes license plate frames to your spec
Old School Automotive License Plate Frames
Also does original decals of your choice

JD, 0024 & 0031 both have their original tail light boxes and both are closed ends?

One more addition to the tail light boxes, open or closed ends. Seems more early cars had the boxed ends but not always.