Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TLea

Pages: [1] 2 3 ... 74
1
Ok, just to clarify, you're saying to take the green/red tracer wire from the intermediate harness (1) and put it in place of the green/red wire (2) that's in the stop-lamp switch plug (coming from main dash harness). Would I then just tape off/clip the unused green/red wire from the main harness? From what I can see on my schematic, this original wire (2) would be pulling power from the headlamp switch.  I take it that the intermediate harness green/red wire will provide power from a different source?
Exactly. Removed wire I've seen cut or taped back

2
1969-1970 Shelby GT350/500 / Re: 1969 Shelby: Help identify this wire?
« on: March 26, 2024, 02:19:14 PM »
Looks like wire that goes to one side of brake switch. Factory under dash will have this cut (disabled) and this replaces

3
Never seen an original up against bearing retainer. They have always been 1/4" +/- away

4
Concours Talk / Re: 1966 Winshield
« on: March 26, 2024, 09:21:39 AM »
Thanks,  Is the logo in the middle near the bottom?
Most I've seen are read on inside but I've seen outside as well

5
Concours Talk / Re: 1966 Winshield
« on: March 25, 2024, 06:55:04 PM »
All clear. Carlite logo

6
Parts For Sale / used GT 350 dash emblem
« on: March 25, 2024, 03:06:33 PM »
Used 68 GT 350 dash emblem, good condition but pins broken off back. attach w/ double sided tape $200 email direct TimothyLea7@gmail.com




7
Parts For Sale / NOS GT 500 dash emblem
« on: March 25, 2024, 03:04:20 PM »
Beautiful NOS 68 GT 500 dash emblem in box $450 Email direct TimothyLea7@gmail.com



8
Parts For Sale / Fender snakes
« on: March 25, 2024, 03:01:54 PM »
These are used original snakes from KR fenders and 69/70 vert 1/4 panels. All will clean up to show condition $300 pair email direct TimothyLea7@gmail.com



9
Parts For Sale / Fender snakes
« on: March 25, 2024, 02:58:41 PM »
These are the Asco reproduction snakes used on KR fenders and 69/70 vert 1/4 panels $200 pair Email direct TimothyLea7@gmail.com


10
Parts For Sale / KR fender emblems
« on: March 25, 2024, 02:56:23 PM »
These are the Asco reproduction KR fender emblems, I have several sets  $200 pair email direct TimothyLea7@gmail.com


11
Parts For Sale / NOS KR fender emblems
« on: March 25, 2024, 02:45:37 PM »
If you've needed these you know they aren't being reproduced anymore so like hen's teeth. This pair is NOS in packages  $400 email direct TimothyLea7@gmail.com

12
Having restored and owning probably 50+ cars over the years and never forgetting a Shelby number there rarely is a day that goes by I don't see one of the numbers pop up. Most common hands down is 007

13
Appeals / Re: '69/'70 Wheels
« on: March 25, 2024, 08:47:52 AM »
Here's another detail not typically found, stamping on outer part of rim

14
Appeals / Re: '69/'70 Wheels
« on: March 25, 2024, 08:45:06 AM »
Here is evidence glue in wheels were produced later than even April. This one dated July 69.  History of this wheel is it was installed to replace one damaged by accident shortly after new so obviously service part. Note several things, first glue in style, second ink stamping on inside of rim (not done on assembly line) 

15
Could that be a 1975 date code? The date of remanufacture?
Might even be later (85/95) as original distributor was at least 73

Pages: [1] 2 3 ... 74