SAAC Forum

Looking for pair of 65/66 strut rod front nuts, oem only. Same all mustang
TimothyLea7@gmail.com

Used 68 GT 350 dash emblem, good condition but pins broken off back. attach w/ double sided tape $200 email direct TimothyLea7@gmail.com

Beautiful NOS 68 GT 500 dash emblem in box $450 Email direct TimothyLea7@gmail.com

These are used original snakes from KR fenders and 69/70 vert 1/4 panels. All will clean up to show condition $300 pair email direct TimothyLea7@gmail.com

These are the Asco reproduction snakes used on KR fenders and 69/70 vert 1/4 panels $200 pair Email direct TimothyLea7@gmail.com

These are the Asco reproduction KR fender emblems, I have several sets  $200 pair email direct TimothyLea7@gmail.com

If you've needed these you know they aren't being reproduced anymore so like hen's teeth. This pair is NOS in packages  $400 email direct TimothyLea7@gmail.com

Trying to decipher early 67 nose fiberglass to fender hardware realizing there are likely different used. For the sake of consistency Id like to stick to cars 1-100. It is bolt, washers and nut.
1. Bolt type , straight thread or leader tip like fender bolt?
2. 1/4" or 5/16"
3. washers, flats both sides? locks?
4. Nuts style, serrated whiz or conventional hex?
5. Probably most difficult, zinc or phosphate?
I have a lot of clues but will hold to prevent bias
Thank you!

Looking for NOS or nice used LF 65 fender , 66 ok too. Email direct TimothyLea7@gmail.com

I had a nos set and took my lenses and gaskets off for safe keeping while bodies were being glassed in. Sadly I can't find, may have got tossed.
Looking for NOS pair w/gaskets. I realize they will probably have the bodies and thats ok. No wanna be's with the tits etc. Email direct
TimothyLea7@gmail.com

54 has its original trunk lid, but it was a bit abused by the time it got to me. Good news is we saved it but my question is this. There are a holes drilled in the rear trunk  corners for the adjustable bumpers.  I was thinking early cars just got the rubber bumpers that snapped into the steel frame of the trunk lid?

What color are upper and lower clutch return springs for 350. My notes say black but that doesn't seem right

3/4 only, will consider version with holes. Email direct TimothyLea7@gmail.com

I need both brackets (long and short), bulb holders and wire pigtails. thanks. Email direct TimothyLea7@gmail.com

Couple early 67 caliper questions. I assume the caliper is same 3/8" 65/66 version w/o the reinforced bar on the side. Are mounting bolts 12 point style or the safety wire style. Are anti rattle clips the large 65/66 style or traditional 67 style?

I need the ones that say Shelby Automotive. Email direct TimothyLea7@gmail.com

I need section for shifter and about 2 feet behind it. Email direct TimothyLea7@gmail.com

Someone measure me the length and diameter of the rubber torsion bar bushing used on 65, 66 and early 67 trunk lid? Thanks

Who sells white scotch locks, not the off white?

Email direct TimothyLea7@gmail.com