News:

We have implemented a Photo Gallery for hosting images right here on SAACFORUM. Check the How-To in News from HQ

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - waltweems

#1
1967 Shelby GT350/500 / 67 smog
May 26, 2021, 02:21:21 PM
I have owned my 67 GT500 for many years.  It was built 1/10/67 in San Jose and should have a smog system but does
not.  I'm not sure if it is likely that I could find the parts to assembly one.  i would appreciate any suggestions.

Thanks.

Walt Weems
#2
1968 Shelby GT350/500/500KR / KR smog pump
February 25, 2021, 04:57:04 AM
I'm looking for someone to rebuild/repair the smog pump for my KR.  Anyone know
of someone?

Walt Weems
#3
1968 Shelby GT350/500/500KR / best conv top for KR
January 13, 2021, 04:25:32 AM
I am looking for a source for the conv. top got my KR and want to get one as correct as
possible.  Mine has the glass rear window. 

Thanks.

Walt Weems
#4
I have owned my 68 KR conv. w/4 speed for over 20 years.  I have seen different sales numbers like 518,318 etc.  Does anyone know how many were sold?

Thanks,

Walt Weeems
#5
My steering column shakes when I pass over a small bump in the road and I am looking for a quality
shop to rebuild the column.

I have done all the easy stuff like new wheels & radial tires, balancing & alignment, balanced drive shaft, rebuilt steering box, new front springs and I'm out of ideas.  I have owned the car for over 20 years and have taken it to two shops, one a shelby restorer but without a solution.

Thanks.

Walt Weems
#6
I have swapped tires and wheels from a 67 GT500 that had no vibration.  I notice the vibration mostly when the road is bumpy or uneven.  I do not feel vibration on the interstate unless there is a bump or pothole.


Walt Weems
#7
Thanks for the help.  I have owned the KR for 25 yrs and the steering wheel has vibrated for years.  I thought it was wheel balance but new tires and balancing along with drive shaft balancing and steering box rebuild has not helped so I thought it may be in the steering column.

Walt Weems
#8
1968 Shelby GT350/500/500KR / KR steering column rebuild
September 22, 2019, 05:47:52 AM
Anyone know of a source for rebuilding the steering column?  Can I remove it without removing the engine?

Thanks.

Walt Weems
#9
1967 Shelby GT350/500 / 67 GT500 breaker points
April 26, 2019, 08:59:49 AM
I'm adjusting the distributor points on my 67 GT500 and seem to remember that .20 is the gap.  Is that correct?

Thanks,

Walt
#10
1967 Shelby GT350/500 / GT500 carb repair
April 19, 2019, 06:03:52 AM
Anyone know of a good carb repair guy in Mayland/DC/Virginia areas

Walt
#11
1967 Shelby GT350/500 / Re: 67 gt500 idle settings
April 15, 2019, 12:25:28 PM
Doug,

Thanks for your advise.  I assume the choke idle screw is  the one under the carb.  Should I adjust them on both carbs?

Walt
#12
1967 Shelby GT350/500 / 67 gt500 idle settings
April 15, 2019, 08:07:23 AM
I have the original holly 600's and the hot idle is 1000 rpm but cold idle is too low and I want to adjust them higher by turning the screw under the carb counterclockwise but want to know if I should increase both carbs or just one and, if so, which one.

Thanks for the advise.

Wat Weems
#13
1968 Shelby GT350/500/500KR / KR oil cooler
March 24, 2019, 05:41:06 AM
I own a 68 GT500KR 4 speed built July 68 and would like to know if the car should have an oil cooler.

Thanks,

Walt Weems
#14
1967 Shelby GT350/500 / Re: 67 GT500 PS hose routing
February 20, 2019, 03:43:53 PM
Thanks for all of the help with the power steering hoses.  I finally did get the clamp oriented properly and things are looking better now.  I also have concourse
short hoses but haven't installed them yet.

Walt Weems
#15
1967 Shelby GT350/500 / Re: 67 GT500 PS hose routing
February 14, 2019, 06:39:45 AM
Sorry! Having trouble adding more than 1 picture at a time.

Walt