News:

SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.

Main Menu

68 Door Stripe Installation

Started by RSOHC, February 11, 2021, 03:11:41 PM

Previous topic - Next topic

RSOHC

Looking for some tips on the installation of 1968 GT500 door stripes.

68blk500c

?just the doors? 
or, side stripes (including fenders and quarter panels?

KR Convertible

If you have stripes on fender and quarter, run masking tape above or below existing stripe.  Use edge of tape to locate new stripe.

KR Convertible

Also, make sure all your gaps are adjusted perfectly first.

KR Convertible

And make sure you have the car on the ground or a storage lift.  The weight needs to be on the wheels.  Gaps change when cars are on a 2 post lift or jacks.

I think that's it this time.

KR Convertible

Nope, not done yet.  Thought of a couple more.

Rocker trim should be on and stripe should be parallel to it.

Make sure paint is clean and smooth.  Use a clay bar or compound.  Use alcohol or similar on inside surfaces of door where stripe wraps around to be sure stripe sticks good.

Coralsnake

QuoteRocker trim should be on and stripe should be parallel to it.

I don't believe that is possible

If you stripe the doors first the stripes should be straight off the doors. The distance to the rocker moldings will vary near the outer ends
The original Influencer, check out www.thecoralsnake.com

KR Convertible

I restriped my car because it was off a little bit and it drove me nuts. 

68blk500c

Doesn't the 1968 Registry include specification for the distance/gap at the bottom of the stripe, as well as the fender placement??