Author Topic: Transverse muffler slots and spacing measurment  (Read 1629 times)

JessC

  • Jr. Member
  • **
    • View Profile
Transverse muffler slots and spacing measurment
« on: April 09, 2018, 04:24:15 PM »
Hi,
I'm building my"clone car" and I'm using  the stock resonators and a Branda transverse muffler. Pipes still have line up wedges on them.Question is how far should I notch the muffler in depth to seat pipes and I could use a measurement on spacing on resonator hanger spacing  "Inside side of bracket to bracket" as sheet metal  on car has been replaced
thank you,
Jess

Scott Fuller

  • Jr. Member
  • **
    • View Profile
Re: Transverse muffler slots and spacing measurment
« Reply #1 on: April 09, 2018, 05:49:56 PM »
Jess,

Email me your shipping address and I'll send you a couple of "blanks" from the mufflers when I notch the inlet pipes.  I had a tool made to notch the mufflers to match the originals and based on the Ford muffler drawings (yes, the muffler drawing has the dimensions of the notch).  I just need to know if you're replicating a 2-inch muffler or 2.25-inch muffler, the notches are different.

Scott 

SFReproductions@aol.com