Author Topic: Stamped nuts for 1966 GT350 Magnum 500 OEM center caps  (Read 202 times)

6s1640

  • Hero Member
  • *****
  • Posts: 851
    • View Profile
Stamped nuts for 1966 GT350 Magnum 500 OEM center caps
« on: September 14, 2021, 05:39:40 PM »
Hi all,

Can anyone confirm that the AMK stamped nut B-10639 is the same nut used on the Magnum 500 center caps.  They look right, but thought I'd ask if any one has purchased and used on the plastic caps.  Below are images of originals, NOS and the AMK nut.

I sent a note to Brant at VCM, but he was not sure if they were the ones or not, but thought they look the right size.

Thanks

Cory
« Last Edit: September 14, 2021, 05:41:25 PM by 6s1640 »

6s1640

  • Hero Member
  • *****
  • Posts: 851
    • View Profile
Re: Stamped nuts for 1966 GT350 Magnum 500 OEM center caps
« Reply #1 on: September 14, 2021, 07:09:53 PM »
Found this nut that actually looks closer to OEM than the AMK nut.  Size is right.

The issue here might be the minimum order is 10,000.  Any body need these?  I will call and see.

Thanks

Cory
« Last Edit: September 14, 2021, 07:25:29 PM by 6s1640 »

NC TRACKRAT

  • SAAC Member
  • Hero Member
  • *
  • Posts: 568
    • View Profile
Re: Stamped nuts for 1966 GT350 Magnum 500 OEM center caps
« Reply #2 on: September 15, 2021, 08:13:10 AM »
Because of the large minimum order, suggest you contact that supplier and ask if they would be so kind as to tell you who has ordered that part in the past.  Then contact those to see if you can purchase a small quantity.  I've done this in the past in similar circumstances and had some success.
5S071, 6S1467