Author Topic: 1967 GT 350 (Early 10/66) Seat Belt Anchor Bolts  (Read 521 times)

1967 eight barrel

  • Jr. Member
  • **
  • Posts: 26
    • View Profile
Re: 1967 GT 350 (Early 10/66) Seat Belt Anchor Bolts
« Reply #15 on: May 18, 2018, 01:47:29 AM »
The Shelby front bolts are the longer shoulder variant, and not the standard production Mustang bolt.  The Y shoulder harnesses are retained by them as well as a chrome spacer. It doesn't use the rubber washers either.
Once you have tasted flight, you will forever walk the earth with your eyes turned skyward. For there you have been, and there you will always long to return.
"If It's Not Boeing, I'm Not Going!"
"Success is not final, failure is not fatal.
It is the courage to continue that counts"

Andrew@MagMustangs

  • Newbie
  • *
  • Posts: 5
    • View Profile
    • MagMustangs
Re: 1967 GT 350 (Early 10/66) Seat Belt Anchor Bolts
« Reply #16 on: May 18, 2018, 11:07:00 AM »
And to clarify for others watching later: The bolts you are referring to for attaching the Shelby Y-Belts to the floors are Not the bolts that would attach the shoulder harnesses to the ROOF on a regular production Mustang. They are the bolts that would attach the buckle seat belts to the FLOOR on a regular production Mustang specifically with Shoulder Harness option, and only used on Trans Tunnel side in normal Mustang.