Author Topic: One piece fuel line, GT500  (Read 1645 times)

nwfire

  • Jr. Member
  • **
    • View Profile
One piece fuel line, GT500
« on: February 12, 2022, 07:37:31 PM »
Can anyone recommend a one piece fuel line for the 67 GT500 that actually fits without making a bunch of changes to it?  Purchased one from NPD and although it says it's for the GT500, it's quite different than the one I have on it now.  Also, any easy way to thread one of these in place??

Thanks.

tonys_shelby

  • Full Member
  • ***
    • View Profile
Re: One piece fuel line, GT500
« Reply #1 on: February 12, 2022, 09:18:53 PM »
Just to make sure, you know the one piece goes down the driveshaft tunnel right.

nwfire

  • Jr. Member
  • **
    • View Profile
Re: One piece fuel line, GT500
« Reply #2 on: February 12, 2022, 10:38:53 PM »
Yes I do.

JD

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: One piece fuel line, GT500
« Reply #3 on: February 12, 2022, 11:08:38 PM »
When I did it the car was a bare shell (no parts on it) on tall jack stands after painting, it was not tough.

Is your car complete, rear suspension and drive shaft in it?
'67 Shelby Headlight Bucket Grommets https://www.saacforum.com/index.php?topic=254.0
'67 Shelby Lower Grille Edge Protective Strip https://www.saacforum.com/index.php?topic=1237.0

nwfire

  • Jr. Member
  • **
    • View Profile
Re: One piece fuel line, GT500
« Reply #4 on: February 13, 2022, 04:40:55 PM »
Yes, drive line, rear suspension, exhaust system is all in place.

tonys_shelby

  • Full Member
  • ***
    • View Profile
Re: One piece fuel line, GT500
« Reply #5 on: February 13, 2022, 06:18:40 PM »
Mine also was bare shell after painting and I didn’t think was hard. Only part was the bend into the engine bay around the frame had to be manipulated a little.

JD

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: One piece fuel line, GT500
« Reply #6 on: February 13, 2022, 10:42:16 PM »
Yes, drive line, rear suspension, exhaust system is all in place.


try removing and or dropping some of the rear components/assemblies until you can sneak it in.
'67 Shelby Headlight Bucket Grommets https://www.saacforum.com/index.php?topic=254.0
'67 Shelby Lower Grille Edge Protective Strip https://www.saacforum.com/index.php?topic=1237.0

vtgt500

  • Full Member
  • ***
    • View Profile
Re: One piece fuel line, GT500
« Reply #7 on: February 17, 2022, 02:10:37 PM »
The Classic Tube stainless fuel line I installed fit fine.