The Cars > 1966 Shelby GT350/GT350H
Collector Gaskets
S7MS427:
Reinstalling the Tri-Ys on my Hertz car. A 3 inch collector gasket is to large and a 2.5 inch is too small. Before I go ordering something else, what is the correct size and does anyone have any suggestions as to what to buy? Headers are back in place and tightened down on the heads.
Royce Peterson:
--- Quote from: S7MS427 on July 17, 2022, 11:57:24 AM ---Reinstalling the Tri-Ys on my Hertz car. A 3 inch collector gasket is to large and a 2.5 inch is too small. Before I go ordering something else, what is the correct size and does anyone have any suggestions as to what to buy? Headers are back in place and tightened down on the heads.
--- End quote ---
You can get the ones that fit properly from Tony Branda.
S7MS427:
Thanks Royce. I was going to call them tomorrow. Any clue as to what size they are?
Royce Peterson:
--- Quote from: S7MS427 on July 17, 2022, 12:42:18 PM ---Thanks Royce. I was going to call them tomorrow. Any clue as to what size they are?
--- End quote ---
They are unique to the Shelby Tri-Y header. After you get them you can measure the diameter but it's not something you can buy anywhere else.
gt350shelb:
if you are not worried about original you can make them from sheet of .060 copper and then never need to replace them .
Navigation
[0] Message Index
[#] Next page
Go to full version