Author Topic: WTB: 1967 Shelby Parts....  (Read 1825 times)

FordGT

  • Jr. Member
  • **
    • View Profile
WTB: 1967 Shelby Parts....
« on: December 09, 2018, 07:18:13 PM »
Looking for the following 67' parts....

 - Passenger side hood pin mounting bracket
 -  Aluminum Tail Light Trim Ring, early style with screw in studs
 - Tail Light Inner steel mounting brackets
- NOS fiberglass quarter panel end caps

Also looking for 1- C7ZE 289 HiPo head in good shape, non-smog..

Thanks, please send me PM....

7777kx

  • Jr. Member
  • **
    • View Profile
Re: WTB: 1967 Shelby Parts....
« Reply #1 on: January 30, 2019, 12:46:57 PM »
I have a pair of original tail-light inner steel mounting brackets from a 67500. Blast cleaned and satin-black powder coated, so ready to go.
please email me at faulknerstevens@btinternet.com if you would like some pictures.
Thanks Alan

Bob Gaines

  • SAAC Member
  • Hero Member
  • *
  • Original Posts:14706
    • View Profile
Re: WTB: 1967 Shelby Parts....
« Reply #2 on: January 30, 2019, 09:49:13 PM »
Looking for the following 67' parts....

 - Passenger side hood pin mounting bracket
 -  Aluminum Tail Light Trim Ring, early style with screw in studs
 - Tail Light Inner steel mounting brackets
- NOS fiberglass quarter panel end caps

Also looking for 1- C7ZE 289 HiPo head in good shape, non-smog..

Thanks, please send me PM....
The correct for your car "tail light inner steel mounting brackets " are determined most successfully by your car's completion date at SA , Shelby VIN and the current style of fiberglass tail panel you have . There are different types that were used originally depending on when the car was built at SA.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

JD

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: WTB: 1967 Shelby Parts....
« Reply #3 on: January 30, 2019, 10:07:49 PM »

The correct for your car "tail light inner steel mounting brackets " are determined most successfully by your car's completion date at SA , Shelby VIN and the current style of fiberglass tail panel you have . There are different types that were used originally depending on when the car was built at SA.

As stated, both cars should be/have "flat" or "raised" Shelby fiberglass tail light panels, as the inner Shelby brackets are different depths.

What are the Shelby completion dates, or is it known for certain if the cars had which panel from new?
'67 Shelby Headlight Bucket Grommets https://www.saacforum.com/index.php?topic=254.0
'67 Shelby Lower Grille Edge Protective Strip https://www.saacforum.com/index.php?topic=1237.0