Author Topic: koni shock mounting hardware  (Read 1638 times)

shelbydoug

  • SAAC Member
  • Hero Member
  • *
    • View Profile
koni shock mounting hardware
« on: February 22, 2019, 05:01:32 PM »
The mounting hardware that came with my Koni's for the fronts used rubber washers to center the bottom of the shock studs in the spring seat.

There's an issue there with that.

The holes provided in the spring seat for the shock studs are 1/2". The od of the studs is 3/8". As a result the shocks move too much in the seat.

OTHER THAN replacing those collared rubber washers, is there an alternative?

I'd actually consider it an adapter. A stepped flat washer with a 1/2" collar machined into a 3/4" washer.

If I had my choice, I'd look for delrin but I haven't found anything yet? Anyone?
« Last Edit: February 22, 2019, 05:06:17 PM by shelbydoug »
68 GT350 Lives Matter!

shelbydoug

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: koni shock mounting hardware
« Reply #1 on: February 22, 2019, 05:02:10 PM »
seat
68 GT350 Lives Matter!

6s1640

  • Hero Member
  • *****
    • View Profile
Re: koni shock mounting hardware
« Reply #2 on: February 22, 2019, 05:51:45 PM »
Hi Shelbydog,

The rubber pieces should have a raised boss that seat inside the saddle holes, preventing the shock from sliding around.  Are your washer just flat with no boss?

Cory

shelbydoug

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: koni shock mounting hardware
« Reply #3 on: February 22, 2019, 06:25:09 PM »
They need to be replaced. I'm looking for something more substantial then rubber washers. If I still had my lathe I'd just cut some out of delren.
« Last Edit: February 22, 2019, 06:27:55 PM by shelbydoug »
68 GT350 Lives Matter!

kram350

  • Full Member
  • ***
    • View Profile
Re: koni shock mounting hardware
« Reply #4 on: February 22, 2019, 09:27:49 PM »
There are or were urethane versions sold by Mustang's Unlimited "Lower Front Shock Mounting Bushing Kit 1965-1973 Mustang
Item # CIN302"

shelbydoug

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: koni shock mounting hardware
« Reply #5 on: February 23, 2019, 07:14:39 AM »
Perfect. Thanks for the help.
68 GT350 Lives Matter!