News:

We have implemented a Photo Gallery for hosting images right here on SAACFORUM. Check the How-To in News from HQ

Main Menu

Hood part number

Started by Shelbypat, April 18, 2019, 12:38:35 PM

Previous topic - Next topic

Shelbypat

Hi all. Any ideas how I could get back my hood part number ?
Previous  body man made a rough job and sand it out as it has been touch at front long time ago. Hood still has potential. Just a bit bowed as usuel.

Bob Gaines

Quote from: Shelbypat on April 18, 2019, 12:38:35 PM
Hi all. Any ideas how I could get back my hood part number ?
Previous  body man made a rough job and sand it out as it has been touch at front long time ago. Hood still has potential. Just a bit bowed as usuel.
The short answer is to make a mold using a hood that still has the numbers . After you make the mold and produce a positive of the engineering number you then graft that into place. There are various ways to accomplish the end result.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

KerryBWhite

Here you go.....

https://www.ebay.com/itm/NOS-Shelby-Fiberglass-Hood-1969-Lower-section/282991201398?hash=item41e3970c76:g:eUkAAOSw8FBbEacG

NOS Shelby Fiberglass Hood 1969 Lower section.  Assemblyline lower hood section , original smooth  AO Smith injected fiberglass lower half with raise S9MS  engineering # visible.


Shelbypat

Tks for inputs. I've ordered silicone mold kit. I'll try it.


Patrick