Author Topic: Hood part number  (Read 2099 times)

Shelbypat

  • Full Member
  • ***
    • View Profile
Hood part number
« on: April 18, 2019, 12:38:35 PM »
Hi all. Any ideas how I could get back my hood part number ?
Previous  body man made a rough job and sand it out as it has been touch at front long time ago. Hood still has potential. Just a bit bowed as usuel.
« Last Edit: April 18, 2019, 01:45:30 PM by Shelbypat »

Bob Gaines

  • SAAC Member
  • Hero Member
  • *
  • Original Posts:14706
    • View Profile
Re: Hood part number
« Reply #1 on: April 18, 2019, 02:47:57 PM »
Hi all. Any ideas how I could get back my hood part number ?
Previous  body man made a rough job and sand it out as it has been touch at front long time ago. Hood still has potential. Just a bit bowed as usuel.
The short answer is to make a mold using a hood that still has the numbers . After you make the mold and produce a positive of the engineering number you then graft that into place. There are various ways to accomplish the end result.
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

KerryBWhite

  • Full Member
  • ***
    • View Profile
Re: Hood part number
« Reply #2 on: April 18, 2019, 03:38:09 PM »
Here you go.....

https://www.ebay.com/itm/NOS-Shelby-Fiberglass-Hood-1969-Lower-section/282991201398?hash=item41e3970c76:g:eUkAAOSw8FBbEacG

 NOS Shelby Fiberglass Hood 1969 Lower section.  Assemblyline lower hood section , original smooth  AO Smith injected fiberglass lower half with raise S9MS  engineering # visible.


Shelbypat

  • Full Member
  • ***
    • View Profile
Re: Hood part number
« Reply #3 on: April 19, 2019, 09:59:11 PM »
Tks for inputs. I've ordered silicone mold kit. I'll try it.


Patrick