Author Topic: T-5 Conversion from Aluminum T-10  (Read 9103 times)

Shelby_r_b

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: T-5 Conversion from Aluminum T-10
« Reply #60 on: August 14, 2019, 08:32:42 PM »
Here's a youtube link to video put out by CJ Pony Parts on how to do the T5 swap.  I must have watched this well over a dozen times both before and during the swap!  ;)

In the video, they do the swap on a 67 Mustang convertible, and you'll notice that the speedo cable is located on the driver's side of the original transmission.  However, on a T10, the speedo cable is located on the passenger's side.  No worries, as I found that you can remove the clamps holding the speedo cable in place along the lower part of the firewall and move the cable over the bell housing and reconnect the cable on the driver's side; which is where the T5 speedo cable installs.

Also, this video shows the install using the cable clutch linkage.

Enjoy!

https://www.youtube.com/watch?v=noj8GAS-sp0
Nothing beats a classic!