Author Topic: KR Placement of dash emblem  (Read 1706 times)

TedS

  • SAAC Member
  • Full Member
  • *
    • View Profile
KR Placement of dash emblem
« on: August 08, 2019, 02:36:47 PM »
Can someone provide placement information for the dash emblem on a KR?

Thanks in advance
Ted

TedS

  • SAAC Member
  • Full Member
  • *
    • View Profile
Re: KR Placement of dash emblem
« Reply #1 on: August 10, 2019, 08:14:25 PM »
Just a friendly bump. Assuming 350/500 and KR emblem placement is the same, maybe someone could post or send me a photo. I can do proportions to figure dimensions
Thanks
Ted

Coralsnake

  • SAAC Member
  • Hero Member
  • *
  • The original Influencer
    • View Profile
    • theCoralsnake.com
Re: KR Placement of dash emblem
« Reply #2 on: August 10, 2019, 08:22:22 PM »

Coralsnake

  • SAAC Member
  • Hero Member
  • *
  • The original Influencer
    • View Profile
    • theCoralsnake.com
Re: KR Placement of dash emblem
« Reply #3 on: August 10, 2019, 08:22:58 PM »
Always in the same place regardless of model

Its actual covering up the holes of the former Mustang emblem

TedS

  • SAAC Member
  • Full Member
  • *
    • View Profile
Re: KR Placement of dash emblem
« Reply #4 on: August 10, 2019, 08:34:58 PM »
Just what I needed. Thanks Pete

Regards
Ted

Corey Bowcutt

  • SAAC Member
  • Hero Member
  • *
    • View Profile
Re: KR Placement of dash emblem
« Reply #5 on: August 10, 2019, 08:55:36 PM »
I used the 3 holes in the metal dash behind the wood grain piece to mark the holes to mount the emblem. But I have an original 350 emblem not sure if KRs are different? But this method worked very well.

Coralsnake

  • SAAC Member
  • Hero Member
  • *
  • The original Influencer
    • View Profile
    • theCoralsnake.com
Re: KR Placement of dash emblem
« Reply #6 on: August 10, 2019, 09:01:14 PM »
I dont think the production KR emblems used mounting studs

TLea

  • Hero Member
  • *****
    • View Profile
Re: KR Placement of dash emblem
« Reply #7 on: August 12, 2019, 07:11:10 AM »
350/500 emblems are pin mounted and go in factory Mustang emblem holes. KR are adhesive backed. After measuring many I am convinced they were hand placed and vary +/- 1/4"  If you cover the factory hole "triangle it kind of only can go in one position +/` 1/4"