Some additional items off the top of my head
The following surfaces would not have been painted
- Fuel pump mating surface - Push in mask installed
- Heater hose attachment ends - Masks installed
- Radiator hose attachment ends at water pump and therm housing - Mask installed
- Water pump shaft end - where the pulley and fan would attache - Mask installed
- If the car was equipped with a ported vacuum switch a slip over mask was installed over it so the lower threads typically have some soft paint spray
Not installed
- Alternator to head bracket or any accessory bracket
- Oil pressure sender extension and switch/sender
- Intake hardware reused so they would be painted though may show a little or more damage from removal and reinstallation
- Fresh new cork end gaskets and white or off white intake to head gaskets. Originals have printing from the supplier on the flat surfaces
- Remember no visible silicon sealer if your tempted to use any
Hope this helps