Author Topic: NOS C5DZ-10884-A misrepresented  (Read 413 times)

Silver Bullitt

  • Jr. Member
  • **
  • Posts: 27
    • View Profile
NOS C5DZ-10884-A misrepresented
« on: September 24, 2019, 02:14:04 AM »
Branda presents a $5 aftermarket C6DZ- style sender (larger width than C5DZ-) in a NOS FoMoCo C5DZ-10884-A box up for auction!

I don't think this is intentional, however they should know better.


https://www.ebay.com/itm/1965-67-NOS-Mustang-Shelby-GT350-289-HIPO-V8-Temperature-Sender-Switch/333338240175

"BRANDA PERFORMANCE INC.
SHELBY & MUSTANG PARTS
*** PRESENTS ***

1965 - 1967 NOS MUSTANG 289 HIPO V8
(FITS ALL MODELS & ALL BODIES)
&
1965 - 1967 NOS SHELBY GT350
289 HIPO V8 ENGINE TEMPERATURE SENDER
1-PIECE

NOS FORD PART#:
C5DZ-10884-A
1 PC SENDER

A BRAND NEW NOS FORD SENDER: 65-67 MUSTANG &
SHELBY GT350 289 HIPO V8 ENGINE TEMPERATURE
SENDER SWITCH, in the NOS FOMOCO WHITE, GRAY,
& BLUE BOX

MADE of BRASS
SINGLE POST

SPECIFIC to the 289 K-CODE HIPO V8

WILL INSTALL / SCREW into the TOP of your:
CAST IRON &/or ALUMINUM INTAKE MANIFOLDS

THIS NOS FORD: 65-67 MUSTANG & SHELBY GT350 289
HIPO V8 TEMPERATURE SENDER, CAME out of a WEST
(UTAH), NOS & ORIG. PARTS LOT

A CONCOURS RESTORATION & REPLACEMENT NOS FORD:
65-67 MUSTANG & SHELBY GT350 289 HIPO V8 ENGINE
TEMPERATURE SENDER
THIS NOS FORD SENDER: 65-67 MUSTANG & SHELBY GT350 289 HIPO V8 ENGINE TEMPERATURE
 SENDER PICTURED, IS the NOS FORD - MUSTANG & SHELBY GT350 289 V8 TEMPERATURE
ENDER you WILL RECEIVE

*** A GENUINE NOS FORD: 65-67 MUSTANG & SHELBY
GT350 289 HIPO V8 ENGINE TEMPERATURE SENDER!!!*** "
« Last Edit: September 24, 2019, 02:18:18 AM by Silver Bullitt »

outlawincorporated

  • Jr. Member
  • **
  • Posts: 34
    • View Profile
Re: NOS C5DZ-10884-A misrepresented
« Reply #1 on: September 24, 2019, 08:22:40 AM »
also I don't believe a NOS unit would have Teflon tape wrapped around it.

just my 2 cents

regards

PHILL BERESFORD
MELBOURNE.
AUSTRALIA.

carlite65

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: NOS C5DZ-10884-A misrepresented
« Reply #2 on: September 24, 2019, 09:03:32 AM »
brandas magazine ads also state that some of his parts are MCA approved. lots of items on his website state the same thing. MCA has not approved parts for over a decade.

Bob Gaines

  • SAAC Member
  • Hero Member
  • *
  • Posts: 2738
  • Original Posts:14706
    • View Profile
Re: NOS C5DZ-10884-A misrepresented
« Reply #3 on: September 24, 2019, 11:17:01 AM »
Something to be a aware of was a habit of some to replace a used or defective part in the box of it's replacement. I don't know how many times I have found used parts for sale in the new Ford boxes at swap meets etc. It is always difficult to convince the owner of those so called NOS parts of the reality. I have seen this even in parts boxes taken from dealership. Not to say this happened here however it has duped many. FYI although not used at the engine plant back in the day later service temp senders did use the Teflon tape. There is also a TSB about it being acceptable to use (years later) also.   
Bob Gaines,Shelby Enthusiast, Shelby Collector , Shelby Concours judge SAAC,MCA,Mid America Shelby

gt350hr

  • Hero Member
  • *****
  • Posts: 1078
  • Randy Gillis in real life - 5353 original posts
    • View Profile
Re: NOS C5DZ-10884-A misrepresented
« Reply #4 on: September 24, 2019, 11:31:57 AM »
 There are a couple of Ford "box/package" buyers out here in So Cal. There are also many people "scrounging" for Ford packaged parts at garage and estate sales who have no clue about the part inside. Usually the same ones that list every part common to a Mustang as an original Shelby part. "Well I didn't know , I just looked up the part number on the internet" , is the normal excuse.
   Randy
Celebrating 44 years of drag racing 6S477 and no end in sight.