During my mockup, I noticed noticed a gap where the AC bracket that holds the pulley meets the PS bracket at the block. Small gap, more like a thick washer. Is that true? I didn't exactly tighten every bolt up, as it was just a mock run, but it gave me pause.
Dropped the engine in yesterday! Looking forward to being on the other side of that mountain.
Thanks again, Chris!
Small block/big block?
Sorry!
68 GT500 428PI
Compressor bracket leg connects to same bolt as upper PS bracket bolt hole.
Yes, but just to confirm - there is no spacer that goes between the block and the upper PS bracket? Outside in is AC compressor bracket leg -> upper PS bracket -> block, correct?
Thanks!
Quote from: Milo on May 01, 2020, 11:33:24 PM
Yes, but just to confirm - there is no spacer that goes between the block and the upper PS bracket? Outside in is AC compressor bracket leg -> upper PS bracket -> block, correct?
Thanks!
No spacer there. Just the compressor bracket leg and the PS bracket .
The spacer is used if you DON'T have a/c.