Just put the rebuilt engine and trans back in 6s855 and am puzzled to see that they seem set too far forward. I believe I may have
mis-assembled the mounts by swapping the top brackets that bolt to the block (C30Z-6068-C) to the wrong sides. This bracket has a "bulge" that is not centered but offset more to one side. I've stolen the only picture I could find from Virginia Mustang that seems to show the "bulge" offset to the front. Mine are offset to the rear. So before I start jacking to remove my mounts for a redo, I'm hoping for confirmation of my screw-up.
Hey Jay, I sent you an email. Give me a call, I'll be up for a while
Dave
Do you have the original mounts? 6S923 was produced at San Jose 1/12/66 and has the standard mounts and not the HiPo ones.
Texas Swede
Early ones were on the car when I got it. I know now they're the wrong ones. Have to get the mounts common to all 289's after 11/65. I'll just add these mounts to my ever-growing extra parts pile. They may even be original hipo's. Guess I'll post for mounts on WTB or get good repros if they exist.