SAAC Forum
Deals and Appeals => Services Offered => Topic started by: Drew Pojedinec on August 25, 2022, 06:50:44 PM
-
Dennis a SAAC member sent me a 3259-1 recently that was *cough* a little rough.
I felt it was worthy of sharing
Afscarbs.com
AirFuelSpark on fb
-
Beautiful work as always Drew!
Chad
-
WOW!!! That's some outstanding work!! Excellent restoration!!
-
Magnificent work, a true craftsman
-
Magnificent work, a true craftsman
Well, more than that.
This is a “services offered” in that you may think your rotten piece of history is history… give me a chance. Maybe it won’t be perfect, but we might make it usable again.
Worth a shot
-
Dennis a SAAC member sent me a 3259-1 recently that was *cough* a little rough.
I felt it was worthy of sharing
Afscarbs.com
AirFuelSpark on fb
That is so true. You did an excellent job on the fire survivor carb I sent you. It may not look perfect, but works great.
Greek
-
Dennis a SAAC member sent me a 3259-1 recently that was *cough* a little rough.
I felt it was worthy of sharing
Afscarbs.com
AirFuelSpark on fb
That is so true. You did an excellent job on the fire survivor carb I sent you. It may not look perfect, but works great.
Greek
This is the same. I cannot fix the pock mark of corrosion, but the insides of this one were perfect. Even the gasket mating surfaces required very very little.
-
Magnificent work, a true craftsman
Well, more than that.
This is a “services offered” in that you may think your rotten piece of history is history… give me a chance. Maybe it won’t be perfect, but we might make it usable again.
Worth a shot
++! I commend your effort help save.
-
Amazing.
-
One would be very hard pressed to find anyone better!!!!! Drews attention to every fine detail whether a rebuild or concours restoration is unmatched in my opinion. Check out his AirFuelSpark page on FB. Amazing craftsmanship and KNOWLEDGE of the FORD Holley carburetor.
-
That is amazing! That carb's "before" photos look like it's been on the bottom of the ocean longer than the Titanic.
-
Great work Drew, thanks for sharing!
-
DP is a carburetor virtuoso.
-
Great work DP thanks.
Save the Carbs!
-
He worked magic on my 3300/3301 BC/BD carbs. Wonderful experience.
-
Do you sell good, American made needle and seat assemblies for Holley 4150 series carbs with LeMans bowls?
-
Do you sell good, American made needle and seat assemblies for Holley 4150 series carbs with LeMans bowls?
I have 1,000 of them… I’ll be totally honest, I have no idea where they were made. They have worked fine for me this far.
I could ask the supplier, but I really doubt they’d tell me the truth.
Best bet if you want american made is to reuse an original steel needle from a 3255. Just re lap the needle to the seat. I have a bucket of them if you wish to try that. I don’t use them as frankly, most people don’t understand the importance of fuel control or filtration, so the viton cause less issues.
-
Fantastic. I will order 6 sets on your site.
-
Nice work Drew. I just looked at your website and Im impressed. I will contact you in the near future concerning my 1967 GT-350s carb. Steve