SAAC Forum

I am looking for a new old stock or good operating original Autolite Starter Solenoid for a 1968GT500. 
I believe that the part number is C7AF-11450 -A1.
The build date for the car is December 28, 1967.
The VIN for the car is 8T02S134516-00957.
Call me a 1-831-455-0439 in California
Or email me at  lauranlhoward@live.com

Thanks
Lauran Howard

The number of the part is C7AF-11450-A1 Autolite.

The part number for the starter solenoid is C7AF-11450-A1 Autolite

The "Petronix 1" has less application problems than later Petronix versions.  Also, some modules just don't work.  If you have a problem, call Petronix and ask for a replacement module.

Can anyone provide who manufactured (ford, motorcraft, autolite) the solenoid for a 1968 GT 500 and the part number?

who is the manufacted the original solenoid and what is the part number?

When I crank the engine when the battery voltage is low, the starter engages with the fly wheel, does not disengage and the engine does not start.  When I am trying to start the engine I can turn the ignition key to the aux position and run position and the starter continues to crank the engine.  I need to disconnect the battery to disengage the starter.  The distributor has a Petronix conversion.  The starter is of original style.  Will this problem go away with a fully charged battery or does something need to be replaced?

Here is a picture of the windage tray that fits a Ford FE.

My persistent rear main leak no longer exists.  Here is the process I used.  (1) Cleaned the read main and engine block with brake cleaner, (2) I changed to a MAHLE brand of seal, (3) Torqued the main cap to 105 ft-lbs before installing the side seals,(4)  lubricated the side seals with Melling assembly lube, (5)  installed nails without points using a 3 pound lead hammer, (6)  Installed new black Fel-Pro gaskets on the oil pan and windage tray, (7)  Covered with silicone the area where the nails were installed.  ( Torqued oil pan bolts to 9 ft-lbs, (9)  Waited one day for the silicone to dry, (10) Primed the system and it did not leak. 

I will be exchanging my covers for comfort weave.  Thanks for all for your help.  Lauran

Attached are NPD descriptions of available upholstery for my vehicle.

The Marti report for my car states that my car came with "Black Knitted Décor Bucket Seats"

Information from the Branda Catalog regarding 68 Shelby upholstery is also attached.

What is the correct pattern for the inserts for the upholstery for bucket seats of a 1968 Shelby GT500 Fastback?  Is it comfort weave, Kiwi, or something else? Attached is a photo of what I have for upholstery in the back seat.

Does anyone have any upholstery experience they would like to share?

I have front seat skins by TMI and cushions from Scott Drake.  Should I try to complete the installation or leave it to a professional?  I have never done an installation before.  I have hog rings and pliers.