Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bullitt1939

Pages: [1]
1
1967 Shelby GT350/500 / 67 GT500 Fan Shroud Repair
« on: May 12, 2023, 11:18:17 PM »
Does anyone repair fan shrouds. Mine has a crack on the top. Not sure the cause, maybe heat or age. I bought a new one, but it’s a smooth finish. I was just seeing if this one could be repaired.

2
1967 Shelby GT350/500 / 67 GT500 Battery Question
« on: February 25, 2023, 11:00:29 PM »
I have a question about the battery in my 67 GT500. I need to replace it and have seen Autolite with and without red lettering on the side. Which is the correct battery replacement?

3
1967 Shelby GT350/500 / Changing rear interior bulb on 67 GT500
« on: September 10, 2022, 09:08:37 PM »
How does the assembly come down? Does it snap out? I noticed it wasn’t working today so need to check the bulb. Just not sure how it comes out since it is behind the lens.

4
1967 Shelby GT350/500 / Replacement Fuel Pump
« on: March 28, 2022, 09:16:14 AM »
Looking for a replacement fuel pump and where to order?

5
1967 Shelby GT350/500 / Question about fuel filter
« on: September 12, 2021, 09:02:51 AM »
I just drained the tank and had the carbs rebuilt. The tank was clean, but the carbs were bad. My question is should I change the fuel filter while I have the car down. Just received the carbs back so everything is ready to go back together. If so what is the correct fuel filter that goes back on the car? I will post a picture of what I currently have on the car now.

6
I have the carbs off so what’s the best thing to clean/polish the intake manifold. Secondly is there anything I can clean the plate with under the hood or just leave it alone. This looks to be the original plate. I can attach an older pic but it has both rev-its now only close up I have of it. I think the air cleaner is made of same material as intake but I never really cleaned or polished it either Roth that just dusting it off more less.

7
1967 Shelby GT350/500 / 67 Shelby GT500 Key Question
« on: June 29, 2021, 11:17:46 AM »
What do the original keys look like? Are they the Ford with Family of Fine Fords on back or Ford with the Mustang on the back? Want to order some original looking blanks. Suggestions on places to order are welcome.

8
1967 Shelby GT350/500 / 1967 GT500 In-board Light Issue
« on: May 26, 2021, 04:09:41 PM »
The inboard are not coming on with the high beams. The relay is not clicking. Where can I get another relay to start there?

9
1967 Shelby GT350/500 / Setting clock
« on: May 22, 2021, 01:59:17 PM »
Can someone tell me how to set the time on the dash clock? Thanks!

10
What’s the best place to buy replacement parts for my 67 Shelby GT500? I need the correct heater core and a new hose clamp. I was shipped the wrong heater core so need to get the right one so I can get my girl running again!

11
Are there any events scheduled in Louisiana for this year?

12
1967 Shelby GT350/500 / Replace 67 GT500 Heater Core
« on: March 13, 2021, 06:02:16 PM »
The coolant is leaking on the passenger floorboard.  I have a new heater core and gaskets to replace just need some guidance. I have removed the glove box so far. Where do I need to drain the hoses? Any help is very much appreciated.

Pages: [1]