Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Carl111

Pages: [1]
1
Concours Talk / Re: Export Brace
« on: May 31, 2023, 07:48:31 PM »
Thank you,

2
Concours Talk / Re: Export Brace
« on: May 31, 2023, 07:46:34 AM »
The car is number 3081, I have had it since 1986. I feel like I will put it on the car at this point.

3
Concours Talk / Export Brace
« on: May 30, 2023, 08:14:35 AM »
Hello everyone, perhaps you can help me out here. I have a 67 GT500 and have had a few different export braces in the garage over the years. The interesting one (that I believe came on the car 37 years ago) has 8 holes, 4 that alight for an earlier car 65 66 and 4 that align with the 67 etc. Has anyone ever seen this? Perhaps it was a leftover at LAX that got redrilled or something? The picture is in primer and a little hard to see, sorry.

4
1967 Shelby GT350/500 / Re: 67 Steering Wheel Restoration
« on: May 14, 2023, 11:36:28 AM »
Jeff Stephens did my 67 wheel, the job was only okay, he replaced a piece of wood and the color was quite different. I called him and he said to stop by when in the area (I drive by there on my way to Ithaca once in a while). Then Covid hit and afterwards I haven't been able to reach him.

5
Is that pat number on the pulley? If not, how is it identified? What is the diameter?

6
1967 Shelby GT350/500 / Re: Early 67 Front Nose Reinforcement Bolt Type
« on: August 22, 2022, 06:48:14 PM »
Hello everyone, does anybody have info about the type and placement of these on later 67 cars (#3081)?
Thank you.

7
1967 Shelby GT350/500 / Re: Power Steering Hoses
« on: August 22, 2022, 01:00:11 PM »
Wow, thank you JD (and Bob), that is exactly what I'm looking for.

8
1967 Shelby GT350/500 / Re: Power Steering Hoses
« on: August 17, 2022, 10:08:00 AM »
Thank you all so much, that is great information. I was also wondering about where the hoses come together by the rubber block/support bracket. Does anyone have any pictures or info of that area?

Thanks again.

9
1967 Shelby GT350/500 / Re: 1967 gt500 pvc hose
« on: August 09, 2022, 08:41:15 PM »
Bob, I'm just curious. With the original setup was there an actual PCV Valve or was this just a crankcase vent? If so was it the "usual" valve or something else?
Care to post a picture?
Thank you.

10
1967 Shelby GT350/500 / Power Steering Hoses
« on: August 09, 2022, 06:42:15 PM »
Hello Everyone, I am a long time Shelby owner (1967 GT500 # 3081) but new here. I am assembling the power steering cooler and hoses. I found a few pictures by searching the site but would love a few more. Does anyone have a few to post here? Thank you so much.



11
1967 Shelby GT350/500 / Re: Period pictures, historical perspective
« on: August 09, 2022, 06:33:14 PM »
The one picture shows a horn hanging from the hood pin bracket, has anyone seen this before?

Pages: [1]