I believe around the third week of April '66.
- Welcome to SAAC Forum.
News:
SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
#63
The Lounge / Re: No roll bar padding left on my original bar- leave or change bar?
November 16, 2019, 06:09:00 AM
There's one on EBay currently. Item # 323947993132. The seller is also on this site - Special Ed and is very reputable.
#64
The Lounge / Re: George Bartell
May 12, 2019, 08:16:56 AM
At one of the earlier SAAC conventions (Dearborn maybe?) many of his one of a kind pieces were up for sale. I'm sure someone can elaborate. So yes, much of it does exist in private hands.
#65
Wanted to Buy / 1967 introduction folder from Stark Hickey Ford
May 05, 2019, 10:40:28 PM
Looking for a black 67 Shelby dealer intro folder from Stark Hickey Ford in Royal Oak Michigan.
Would like to purchase outright or possible trade.
Would like to purchase outright or possible trade.
#67
Wanted to Buy / 1966 Holley 715 CFM carb
January 13, 2019, 11:00:48 AM
i'm looking for an original '66 Holley 3259-1 carb dated 633, 622, 612 or late 65 date. Prefer complete carb, but could use main body too. Thanks
#68
The Lounge / Re: Shelbys, Mustangs and Fords in Movies or TV
December 28, 2018, 01:02:10 PM
A Cobra Jet car too!
#69
1967 Shelby GT350/500 / Re: 1967 GT 350 (Early 10/66) Door Panel Rear Screw
November 17, 2018, 08:46:20 AM
There was a technical service bulletin that addressed the door panels pulling away. The fix was to add a screw to the rear center area.
#70
Up For Auction / Re: C6AE "HiPo" block on craigslist
October 31, 2018, 03:50:37 PM
Yes, all hipo blocks were cast in Cleveland. None were C6AE castings either.
#71
Wanted to Buy / Re: Ford 390 fe engine block.
October 08, 2018, 03:44:04 PM
Not sure what he's asking. He said to call him.
#73
1969-1970 Shelby GT350/500 / Re: Exhaust Tip Defector
October 08, 2018, 10:04:49 AM
These were sold years ago by a Shelby vendor. Can't remember which one though.It's purpose was to keep the exhaust off of the rear of the car. Had nothing to do with the fuel.
#75
1967 Shelby GT350/500 / Re: 67 GT350 Original clutch Fork -need picture
June 13, 2018, 12:51:20 PM
The Ford catalog lists C7ZZ-7515-D for 289 hipo and 390 engines. 12" long. Never found out if this is an error though. I have an NOS one I'll try and dig out.