Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gt350bp

Pages: [1] 2 3 ... 28
1
Appeals / 94 Bondurant Mustang GT school car
« on: Today at 08:02:05 AM »
Looking for someone who has knowledge on the Mustang GT's used in 1994 for the Bondurant Race School. Found a possible GT that has been sitting and it will need a complete restoration. Any help or knowledge on these cars is appreciated. I have the basic knowledge of the articles and prior auction sales but would like someone who would know the details and may have an original or restored car that would be willing to share their knowledge.

Thank you.

Don
gt350bp

2
Florida Region SAAC / American Muscle Car Museum 3/9/24 photos
« on: March 10, 2024, 05:58:38 PM »
Nice crowds for the Brevard AACA show yesterday at the American Muscle Car Museum in Melbourne, FL. A few photos attached.

3
1965 GT350/R-Model / Re: Interior door handles
« on: February 07, 2024, 06:00:27 PM »
Thanks Jeff!

4
1965 GT350/R-Model / Interior door handles
« on: February 04, 2024, 09:23:23 AM »
Can anyone advise on the correct fasteners to secure the interior door handles for a San Jose produced Mustang? Not an early car that would use the "Jesus" clips.

Thank you.

Don
gt350bp

5
Swap Meet / Misc. 1/25 model parts
« on: January 21, 2024, 12:40:05 PM »
Found a small box of misc. 1/25th scale model parts in the attic. Some American Racing 200S wheels and three (3) Minilites wheels are included. All parts are from
Ford related kits.

Free to a good home. First to PM me and request will get them.

Don
gt350bp 

6
Parts For Sale / 68 small block shifter
« on: January 21, 2024, 12:34:41 PM »
For sale:

68 small block 4-spd. shifter for sale with new lever, mounting bolts and standard shift knob. Very nice control box. $350 + shipping from Daytona Beach area.

Don
gt350bp
(386) 756-9289

 

7
Appeals / Re: SW 240A fuel pumps
« on: November 25, 2023, 06:28:22 PM »
Pretty sure the GT 350R's left the factory with a single SW 240A attached to the L.H. trunk hinge support. Only picture that somewhat shows this is in the 65 Registry. (I think that photo was originally in the May 65 Road and Track article on the 65 Shelby's.) Hoping there is a period correct photo in another magazine or maybe even a Shelby memo or sketch that would be a little more detailed.

Don
gt350bp

8
Appeals / SW 240A fuel pumps
« on: November 15, 2023, 07:26:00 PM »
Can't find the recommended inline fuse amperage for a SW 240A fuel pump in the spec and installation sheets I have. Can anyone verify the amperage?

In addition, is there any good period correct photos of an original R-Model SW 240A installation that can be shared?

Thank you.

Don
gt350bp 

9
I am running 215/70 x 15 front and 255/60 x 15 in the rear on my KR.

Don
gt350bp

10
Appeals / Help identifying front coil springs
« on: October 26, 2023, 12:29:24 PM »
Need help identifying front coil springs. I think they came from the 69 Boss T/A replica I was building. They are 11 5/8" long.

Any help is appreciated. Thank you.

Don
gt350bp

11
For sale:

69 Shelby convertible diecast collection $225 Four (4) cars in photo.

69 428 CJ GT $70
68 GT 500KR $30
Yellow Ford GT $50

Shipping will be calculated on actual cost. Can pick up at the Daytona Rod Run swap meet over the Thanksgiving holiday. Will have more diecast and a large selection of Shelby and Ford plastic model kits available.

Don
gt350bp
 (386) 756-9289 Daytona Beach area

12
Misc. For Sale / Diecast models for sale
« on: October 20, 2023, 08:06:40 PM »
Diecast models for sale:

I have the following Trans Am / GTO Series diecast models to sell as a set. These are new in the box and never displayed. Only removed from the outer boxes  twice to check when bought and to photograph. Models are as follows:

GMP #3 Ron Fellows Sunoco Camaro
GMP #11 Scott Pruet Motorcraft Mustang (Missing outer box)
GMP 7-Eleven Bruce Jenner Mustang
GMP #1 Dorsey Schroeder Whistler Mustang

$1,200 for the set + actual shipping cost

Don
gt350bp
Daytona Beach area


13
The Lounge / Re: What happens when selling your Shelby?
« on: October 14, 2023, 09:56:19 PM »
Car worth X and parts worth 3X?

Don
gt350bp

14
1967 Shelby GT350/500 / Re: Installing headers on 67 GT500
« on: October 13, 2023, 08:17:01 PM »
Roy,

Had to switch the balance on the engine to get it to set down in correctly.

The 482 was built by Keith Kraft and he suggested TD rockers, stands and shafts, so that is what I am using. The cam is a solid roller and am very happy with the results. Engine runs and sounds great with the solid lifters.   

Things have been going pretty well here in the swamp, but after 30 years in Florida, I am getting priced out. Insurances and unbridled coastal growth has me looking for cheaper property back up in Western Pennsylvania. I used to live in a town that was considered the best kept secret, but local politicians have let the growth over run the infrastructure. Traffic nightmares, flooding and new apartments and storage facilities on every available space.

Don
gt350bp

15
1967 Shelby GT350/500 / Re: Shifter Difference between GT350 and GT500
« on: October 12, 2023, 08:07:46 PM »
Just restored my 68 KR shifter and attached are photos of a small block and big block shifter and rods. Big block reverse shift rod is bent slightly different and has a bevel on the end for clearance. The slot in the shift rod for adjustment is slightly longer as the shifter reverse arm is bent vs. the small block is straight.

Don
gt350bp

Pages: [1] 2 3 ... 28