SAAC Forum

Thanks Pete, appreciate you taking the time to post this.
I will check it over next weekend and hopefully find where I have gone wrong.
Cheers.

Quote from: Coralsnake on April 06, 2023, 05:15:07 AM
Male plug with black in lower photo should be attached to lead from headlight switch

Do you have the sequencer delete wiring diagram?

Thanks Pete
Black male plug is now where it should be!

The sequencer delete wiring diagram I don't have and would love a copy, or advice on where I may be able to get one.

Cheers/thanks.


l

I have a couple of issues I can't quite solve, any advice gratefully received.
All wiring front to back has been replaced with new Alloy Metal Products wiring.
1. Fog lamps are working perfectly but the male plug with black wire(pic attached) is not plugged in anywhere and I can't figure out where it goes.It is live when the fog light switch is on.
2. Hazard lights flash at the front and the dash when on, but not at the back. Indicators work correctly front and back. My car has the sequencer delete harness (pictured). I can't see it being the flasher as surely they wouldn't work front or rear if that was the issue?

Pete, pics are from your website I hope you don't mind.

Thanks in advance as always.

I got mine from Dead nuts on couple of months ago, my original was long gone so nothing to compare the reproduction to but it appears to be good quality to me, is not bakelite of course.

Thanks Bob appreciate your advice as always, apologies for delayed reply.

Thanks Bob, PM sent.

Fired the KR up today, first start since resto began 2/3 years ago so a very rewarding day.
All went well, no leaks etc, just a couple of guage issues to sort.
Oil pressure guage not reading correctly, just goes hard right as far as it can.
I bought a sender unit from NPD link but now suspect that unit is for mustang guages only, not Stewart Warner and is causing this issue.
Found a thread on here that says I need "stewart warner D-353-Z' sender(thank you Coralsnake)
My question is, does it have to be a NOS or used sender, or is there a new alternative that works.
I searched the Stewart Warner website for D-353-Z and nothing came up.
Thanks in advance.

Is the front mesh grill painted?
Thanks as always.

Thanks gents.

I think I may have a tach problem. Car has a new AMK products main underdash wiring harness "with tach" installed. Today I ran the wires to the tacho, pink wire to black plug on tacho and red wire to the red plug on tacho.This resulted in no voltage at coil. When we bypassed the revcounter we got power back at the coil.Testing with a multimeter shows no power is passing through the revcounter.
Does that sound like a "burnt out" tacho?
Are they repairable?
I would very much like to keep the original tacho so would prefer to repair if possible.
Thanks in advance as always.   

I would just like to thank Mr Gaines for all of the free advice he provides on the forum and the non judgemental way in which he dispenses it.
To state the obvious we are very lucky to have him here, thank you Sir....

Thanks gents, hope to have 4159 on the road around Easter.

Are repro's available?
I can't find them anywhere.
Thanks in advance as always. 

WCCC has original/used versions.

Quote from: Coralsnake on December 05, 2022, 06:54:16 AM
I have not seen metal under the folding seat brackets before? Is that something added to the car?

Motor mounts were all bare steel, except the rubber insulators

Hi Pete,
Not added by me the car came that way, have attached a clearer pic.
Looks like spot welds at the bottom if you can make that out in the pic, its the same on both sides of the car.