SAAC Forum

Planning on getting a 2nd set of wheels for radials to swap out originals for driving around. Any suggestions on part number and where to buy 10 spoke wheels for a 68 GT500KR that fit properly?  Thanks

Looking to buy an original trunk lid for Shelby GT350.  Thanks

Looking to buy original rear seat belts, heater box, and a heater plenum.  Looking for an undamaged heater plenum.  Thanks!

Hello, I have a 68 Shelby GT350 and I'm looking for someone that can professionally restore the front and rear seats.  If anyone has any recommendations, please forward their contact information to me.  Thank You

Hello, I have the front seats and rear seat that I'd like to have restored for my GT350.  The original seat covers are in great shape but the foam and rails need restoration.  Any recommendations on a company that specializes in this?  Thanks

Wanted 68 GT500KR Convertible, original sheet metal, no rust, original drivetrain.  Thanks!

I have a 68 KR original exhaust system for sale.  Still on operating survivor KR fb that's been well cared for and garaged.  It appears to have never been removed.  In good condition.  $13500.  PM me if interested.

Looking to buy a 68 KR convertible for my own use.  Must be original drivetrain, original floor pans and body panels, little to no rust.  Automatic or 4-speed okay.  PM me with details.  Thank you!

My 68 KR has the original factory exhaust system, including muffler, never been removed.  The piping and muffler are in fair condition.  I will restore the car at some point but wanted to know if anyone has advice/experience on restoring the exhaust system.  Is it practical to restore the original exhaust piping and muffler?  Thank you in advance for any advice.

Looking to purchase a 1966-1968 Mustang.  Must be original drivetrain and floor pans, no rust.  Thanks

Looking to buy original smog equipment for 68 GT350.  Thanks

Wanted to buy original Holley Carb spacer plate for a 68 Shelby GT350 4-Speed.

Wanted seatbelts for rear seat.

Looking for original steel wheels.

Is anyone familiar with Ziebart undercoating?  Have a 68:that had this applied when the car was new, not sure if this negatively effects the value of the car..

Want to buy original distributor for a 68 GT350 4SP.  Thanks!

I have a GT350 the previous owner removed the vacuum hoses from the engine compartment.  I'm replacing the hoses, but wanted to see if someone has photos of the house routing to the motor and where it should pass through the firewall.  Thank You!

Does anyone know how to identify if the motor is original to the KR?  Is the partial vin stamped on the block anywhere?  Thank You!

Hi, I've been looking for an original Holley for a 4-Speed GT350.  Does anyone have photos of an original stamping and are there other ways to determine original versus a re-stamped carb?  Thanks!

Looking for 68 GT350 Original Holley Carb.  Thank You.