SAAC Forum

I purchased a 1968 style Shelby Roll bar from Tony Branda also purchased a 3 point harness from Classic Industries which are supposed to bolt on to the roll bar for 68 Shelby . Is there some sort of bracket that goes in between the roll bar harness mount location and the roll bar that I am missing? Here are some pics.

The hole on the roll bar mount does not seem to line up with the big hole on the harness reel.

Quote from: WT6066-2600 on July 15, 2022, 06:07:04 PM
Happen to have this original KR hood in garage, if you want closeups of rivets with a tape measure locating them, Send PM with email and I will forward photos. Good luck

Will do and thanks!

Quote from: TLea on July 15, 2022, 04:25:52 PM
https://concoursmustang.com/speegle/65-70%20Shelby/Article%20-%20Master%20-%20Bonding%20KR%20Plenum%20to%20Hood.pdf

Awesome and thanks!

I am building a 1968 Shelby GT500KR clone and I am wanting to mount the ram air chamber to the reproduction Tony Branda 68 shelby hood that I purchased. Can somebody tell me or show where all the rivets where located to hold the ram air chamber underneath the hood and also what sealant I could use to seal it to the hood?

I would appreciate any help and thanks!

I am looking to buy a new reproduction 1968 GT500 hood,trunk lid,head lite buckets,etc from Tony Branda. Does anybody know if those fiberglass parts he sells are close to original looking in design and are not really rough looking with terrible design that is knowhere close to original looking. They told me that Legendary makes them out of Canada.

Just trying to get some feed back before purchase. Thanks!