Thanks Royce Peterson.
SAAC Member Badges are NOW available. Make your request through saac.memberlodge.com to validate membership.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Show posts MenuQuote from: TLea on October 15, 2022, 07:34:05 AM
The only point of all this is so the poster can get the correct rods. If he's looking and asking we would assume that he does not have his originals therefore he just needs to find the correct engineering number and measure the rod bolt diameter and that should satisfy his request. The farther benefit is to inform that the engineering number does not necessarily mean it is the correct rod and it is up to him to discern the difference
Yes I need to know the correct Assembly Line cast numbers and the size of the bolts.
Quote from: 430dragpack on October 09, 2022, 09:36:47 PMQuote from: J_Speegle on October 09, 2022, 07:06:01 PMQuote from: Kyle on October 09, 2022, 02:53:50 PM
Still not shure what were they from factory?
C6AE-C or C7AE-B on a 428 cast date 1966 September?
Based on my records and the examples I've documented - C6AE-C
Do you have notes on large rod bolts or small?
Quote from: J_Speegle on October 09, 2022, 07:06:01 PMQuote from: Kyle on October 09, 2022, 02:53:50 PM
Still not shure what were they from factory?
C6AE-C or C7AE-B on a 428 cast date 1966 September?
Based on my records and the examples I've documented - C6AE-C
Quote from: TA Coupe on October 07, 2022, 05:49:12 PM
Kyle, I sent you pictures of emblems a few months ago and you never said anything. I do still have the Cobra air cleaner lid. I will send you an email.
Roy
Hi Roy,
I did not resived the Email about the pictures of the Emblems.