SAAC Forum

Up for sale a refurbished by Chockostang power steering assembly line idler arm with C7ZA-3355-B numbers. This one is in raw metal and has been protected with boeshield. For 1967-70 with power steering.

$800 shipped obo

Thanks

Jon

Quote from: alex_st on September 10, 2023, 04:32:51 PM
So this is not the original block then. Correct?

Correct.

All 67 GT 350's had 289 hipos.  All 289 Hipos were C5AE blocks cast at the Cleveland, OH foundry.  All C6 blocks were cast at the Windsor, Ontario Canada foundry and none were 289 hipos.

Jon

No C6 blocks were hipos.

Jon

Up for sale a correct power steering idler arm OEM version without C7ZA numbers.  Refurbished by chockostang. 

SOLD!

Thanks
Jon

What I believe to be the correct pinion yoke for 65-67 Shelby (maybe more).  For 1330 u joint, 5 1/8" overall length, 4 1/8" width with earlier dust shield.

More pictures on request.
SOLD!

Thanks
Jon

4 used headlight bulb retainers for 1967 Shelby and other fords using 4 headlight system (5 3/4" bulbs) for sale.  Bonus 5th one needing a spot weld to re connect.

Stainless rings that hold bulbs, not exterior chrome trim rings.

Sold to Fran...sorry Bob.

PM any interest

Thanks
Jon

I have 4 used originals.  Plus one more needing to be spot welded back together.

PM if interested.

Jon

I have 2 chockostang refurbished ones.  1 with numbers, one without. 

They were not inexpensive.

I could part with one.  The one with numbers is worth more than double of the one without.

Jon

Up for sale a like new set of Scott Drake repo 67 10 spoke caps.  Unfortunately no backing plates or fasteners.

SOLD!!!!

PM any interest

Thanks
Jon

Quote from: 67 GT350 on July 09, 2023, 10:24:06 PM
Looks great! What size tires did you put on??

225/60/15 all around

Jon

First ride in #2325 after over 17 years off the road due to a longer than expected resto.  Still need to tweak a few things and upgrade a few parts, but 95+% done.   Are they ever done?....

Jon

ACP power steering 67-70 idler arm as new.  Close but not exact to oem.  Painted in cast iron paint and yellow stripe.  I found an original and do not need this. Was installed but never driven when installed.

SOLD! 

Thanks for looking.
Jon

Up for sale a very nice smooth top late 66 date 1967 289 timing cover.  No corrosion issues.  Includes original dipstick tube. Slight grinding on inside where cam gear must have not had enough clearance.  Not a big deal and not seen once installed.

PM any interest

SOLD!

Thanks
Jon

Check dashpot adjustment on carburetor?

Jon

Not sure about 66 but I think you need C7OE-6750-B for the 67. There are usually plenty of these available on EBay.

Thanks
Jon