SAAC Forum

What would the correct "PAINT-OK" stamp and correct location? I have seen right side on cowl, but also have seen discussion on fenders. Yellow in color. April '66 car. Thanks

Just picked up this wrench and 25 lugs.  13/16" lug size,  1-15/16" long? Anyone know what these are?

In the ad "HOW TO MAKE AN ITALIAN CRY" are those '65 side stripes? The center stripe appears to be above the bottom door line and the 0 in 350 seems to have no stripe between it and the door line?

Can anyone supply the measurement of the wheel lip height thru wheel centerline with Crager's and Blue Dots, front and rear? Thanks

Can anyone supply the measurement of the wheel lip height thru wheel centerline with Crager's and Blue Dots, front and rear? Thanks

The fuel line clamps on the rubber line from the hard line to the fuel pump are the permanent crimp type? Was the crimp located in a particular orientation; down, up, toward the front, angled forward, etc... ? Were the clamps the non-dimpled type, like the ones at the carb filter? Numbers in the assembly parts book call for a 8287. Any info appreciated.

When the front fender bolt was removed and replaced by the Hood Bumper Assembly C4ZB-16763 (for the hood pins) should there be bolt washer witness marks in the fender paint, or was this bolt left out during fender assembly along the line? If the bolt remained could this bolt have been used by SA for the Monte Carlo bar?

I have two front grills, on one the edges of the horizontal bars are flat when viewed from the end of the grill (off the car) and the other has an angle cut that reveals more of the slat. Which is original or are both original? All the rivets are the same on both. Thanks

I have seen lock nuts under the bolt heads and no lock washers. Does anyone know where the split washers are supposed to be located? The nuts I have are self locking but having two methods of security seems redundant? Thanks